answersLogoWhite

0


Best Answer

Remove the black panel that surrounds the dash cluster. There are two right above your guages (facing up) and two facing down. The ones facing down are covered by a square black panel, right in front of the speedometer/tachometer, you just pull it up and it will pop off and expose the screws.

Then, you need to put the parking brake on, leave the car off (but turn key on) and put the gear shifter all the way down, and tilt the steering wheel all the way down.

Now you can grab the piece that is around the dash cluster, and carefully pull it out.

Now you can see that there are 4 Phillips screws holding the dash cluster to the dashboard. Remove all 4, tilt the cluster down, and it will slide right out. You can now see that the lights are held in little grey housings, you turn them counter-clockwise to unlock them and then pull them out. Installation is reverse of removal.

User Avatar

Wiki User

12y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you repair instrument cluster lights on 2004 Grand Caravan?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you repair Instrument cluster lights on 2002 Mercury Sable lights do not work except the turn signal lights in cluster are always on?

You Will Have To Take To A Dealer. Best Of Luck


How do you repair instrument panel lights that doesn't turn on on a 1995 GMC Suburban?

To fix the 1995 Suburban instrument lights, check the light fuse first. Check the light switch. If these are ok, then check the instrument cluster for proper power and ground connections.


How do you repair instrument cluster electronics 1990 Volvo DL?

Repair is a big word.as there are several components to the cluster. What symptoms does it display?


Who repair instrument cluster on 94 ES300?

DNA Speedometers are the BEST


How do I repair 1994-96 C4 Corvette lcd dash cluster?

how do i reset the sensor on the instrument cluster on a 1984 corvett?


Your instrument panel on a 2002 Mercedes c240 will not illuminate what could be wrong?

This is cluster failure! The instrument cluster will need to be replaced this is usually done by certified Mercedes repair facility


How do you repair wiring of instrument lights for 1990 Nissan?

Remove the instrument cluster and replace the bad bulbs. Take the battery cables off!Remove the upper and lower steering colum covers. Remove the four screws on the cover. Tke the screws out of the cluster and turn it over. Replace the bad bulbs. Had to replace the whole cluster on mine as the speedometer and the heat guage were kaput!


Digital odometer is not working Buick Century?

search for instrument cluster repair in search engine


How do you repair a 1998 Lincoln Navigator ac and instrument cluster that is not working?

It will have to be removed and sent off for repairs.


What Fuse number are the Dashboard Lights on a 1998 Silverado 5.0 Liter?

It Should Be Number 4. If It Is OK , Then Check # 1. If All Fuses Are OK Your Instrument Cluster May Be Burned Out. This Is Just About Always A Dealer Repair.


How do you reset check lights on Dodge Caravan?

Take it to your local Parts Store and have them scan the cars computer Repair the Problems. The lights will go out.


Why does the hazard lights on a 1998 acura integra make the gauge cluster lights flicker on and off?

If I understand the question correctly, when you turn on your Hazard lights, the back-lighting of your instrument cluster flashes too. This is not normal. The Hazard lights should only affect the turn signals and the turn signal indicator lights in your instrument cluster. This is a wiring issue, specifically a short circuit between your hazard flasher circuit, and your instrument cluster backlighting circuit. Although I am not familiar with an Acura Integera's circuitry, I believe the short exists in this area because your instrument cluster backlight operates in a flashing pattern. It is apparent that the hazard flasher circuitry is finding ground through the circuit responsible for the instrument cluster backlight. If this is the case, to solve the problem all you have to do is isolate the short and wrap some electrical tape around the exposed wires, individually, for a quick fix. However, gaining access to the wires and locating the short may be difficult and frustrating. You may want to have your dealer or an experienced individual repair this for you. If you recently had an aftermarket alarm installed, they may be responsible for this issue as well, since lighting circuitry is altered for the alarm's functionality. -APTech