yes it will be i got the 17 inch wheels for my 2003 galant and they fit like a glove.. not the OJ glove lol
I believe that the airconditioner condensation drain is plugged. How do I clear it?
It is located behind the glove box. Remove the glove box completely and it is attached with two screws. Hope this helps
the cabin filter is located behind the glove box. Look in your owners manual. you have to remove the glove box to access the filtewr.
under the passenger dash. You have to remove the glove box and lower trim to get to it.
It's inside the glove box, you'll see two screws remove these and pull filter out.
I don't know the answer but any glove box lock is a joke. I would just replace it but never lock it.
according to mitchell ondemand its behind the glove box
Removing a glove box door on a Mitsubishi Colt is simple. All you have to do is unscrew the bolts that is holding it together and take it off.
The time to replace a baseball glove is when the laces are very stringy/ in stards, the pam of the glove as no more padding, the glove is to small, and wen the person using the glove has no more feel of the glove.
Replace any broken parts or adjust latch assembly
Under the glove compart
The cabin air filter on a 1999 Mitsubishi Legnum is located behind the glove box. The filter can be removed once the glove box is released and taken out.
The resistor is located on a duct behind the glove compartment and the glove compartment back.
You have to take off the glove compartment, and some other paneling to get to a little motor with a whole bunch of gears right behind your center console. Just put grease (or Vaseline) on all of those gears, and you should be good to go!
Which model of Mitsu? Some are behind the glove box, and you must take the box out and a nut or to from the firewall, and the blower should be clear from then. 1988 mighty max 2.0L
2008 lacrosse glove box
The ecu is located behind the blower assembly.remove glove box door its behind the duct which is removable with three fasteners and a connector that's on the duct on the left of the blower housing.ecm is mouted only with a 10 mm bolt be sure to disconnect battery before removing and replacing.
Have to remove the whole glove box first
It's behind the glove compartment. You née to remove the contents, remove the drawer. Secure the retractor cable, remove 6 Phillips head screws, pull the right side snap locks loose then remove the glove box backing. The air intake is behind that panel and is nearly impossible to remove. You should get a professional to do the laborious work for you.
the blower motor resistor is located behind the blower motor which is located behind the glove box there is clip wires you need to disconnect and then connect the new one.
under the glove box,white connector,rectangle
You can find behind the glove box compartment.
just open glove box completely out its behind there Go to www.autozone.com where they have a great repair section that is pretty much the Haynes auto repair book online and best of all it's free. They should be able to tell you how to do any repair.