If the antenna does not motor in and out, it can be the antenna mast OR the motor assembly. Usually you can hear the motor moving and if so, it may be ok. It is probably a broken or worn out or badly installed antenna cable. The antenna mast has a nylon sprocket cable that winds in the motor assembly and that sometimes break or wears out so you need to replace the integrated antenna mast-nylon cable assembly.
To replace the antenna mast or to reinstall the mast, you must first remove the nut on top of the antenna by using needle nose pliers. Turn the radio on while pulling on the antenna, it should come off easily and the nylon cable protrudes at the bottom, pull on it and you should see about 1-2 feet of cable.
If the cable is ok and not broken or worn out, perhaps it was badly installed (or it is actually broken and a piece of it is in the motor spool). The sprockets need to point in a particular direction (try front or side) to work properly. Reinstall and check for proper operation.
To reinstall, turn the radio off and feed into the hole while the motor is winding, it should be caught and reeled right in. If problems continue, you need to replace the mast or perhaps the nylon cable is broken inside the spool in the motor assembly
The mast is relatively cheap online and can be installed as described above.
To get to the motor assembly you need to access it from the fender. Remove the cover of the wheel well (that prevents mud/water from entering the engine compartment) and the motor assembly will be accessible. Remove one screw to drop the assembly. If you need to change the assembly, this is it.
If you are to change the antenna mast and there is some broken cable inside, continue by removing the plastic cover to uncover the assembly. There is a black plastic cover on top that you must then remove to access the wheel that winds the antenna nylon cable. Now you can remove the broken cable.
http://www.antennamastsrus.com/Instructions%20Mast.htm
how do you replace a antenna motor for a 2000 Toyota landcruiser
what is the cost of repair of Toyota 4runner exhaust manifold
Most antenna in cars can just be unscrewed at the base. You may have to disconnect a wire at the base though. Check your owner's manual or a car repair manual for more details.
I used Lucas stop leak not a fix but it does work....
To repair a loose folding side view mirror on a 1998 Toyota 4Runner, slip a matchbook cover into the gap where it is loose. Any piece of cardboard will work. A person can also take the mirror off and secure the screw with plumber's tape if it is loose at the screw.
An oil leak on a 1995 Toyota 4Runner can often be repaired by replacing the damaged gasket or seal. Tightening the oil pan bolts can also fix some leaks.
Remove the wiring harness from the bottom of your 1987 Chevy Corvette power antenna. Remove the power antenna retaining nuts. Reverse the process to install your new power antenna.
you can buy repair books one is the haynes repair manual#92075.It has wireing diagrams in the back or go to the dealer
Fuel injectors i'm told. Have same issue and this is what my mechanic told me. 3.0 3vze V6
i dnt really no but i no i has somthing 2 do wit the car hahaha lols
Not sure amount repairing one, but I just replaced one tonight on a 98 4Runner for $127.00 Autozone- Lifetime warranty!
Bring the destroyed external antenna to the store where you purchased it. Or visit any repair shops near you which will be able to repair the external antenna.