0
How do you repair the 4 speed fan control on a 2002 jeep liberty Positions 1 and 2 are out. Positions 3 and 4 work fine?
2roadrunners
You need to replace the blower motor resistor. It is a circuit that uses different resistors for different speeds. They routinely burn out....
Wiki User
∙ 16y ago
Add your answer:
Earn +20 pts
What is the code p1683 on a Jeep Liberty?
P1683. Speed Control Power Relay Or Speed Control 12 Volt Driver Circuit
How do you repair the 4 speed fan control on a 2002 Chevy Prizm positions 1 2 and 3 are out?
sounds more like blower motor resistor cost about $30.00 from dealer and 2 screws hold it in place
How do you repair the fan speed control for ac and heater in a 2004 Chevrolet Impala?
Perhaps a bad fan resistor
What does engine code PO507 mean and how do you repair it?
Engine code P0507 mean High idle speed. Check out the the idle speed control motor(ISC). LOCATED near the throttle body.
Why would the ac fan switch on a 2000 Camry work only on the last two positions and not the first two?
Electrical contacts in the first 2 positions have become either corroded or burned. Replace fan speed control switch.
Why does your Precor 9.22 treadmill keep getting an error code of L5?
You may need to repair the control speed board. It's a classic fail.
What is vf speed control?
It is used for sensorless motor control. With vf speed control u can control speed of any induction motor.
What is speed controller?
It is used for sensorless motor control. With vf speed control u can control speed of any induction motor.
2002 Jeep Liberty 4X4 Sport Number 2 setting on the fan speed control of the climate control on the center council is dead Number 1 3 4 are working though Any help appreciated?
bad blower resistor
How do you repair a speed sensor for a 1996 150 ford?
Not much you can do to repair that other than replacing it.
What wind speed will the statue of liberty's torch blow out?
Are you serious????
Why does your car shake when you hit 50 miles per hour?
Probably there is something loose. If you frequently go at that speed, I would suggest you consult with a repair shop.Probably there is something loose. If you frequently go at that speed, I would suggest you consult with a repair shop.Probably there is something loose. If you frequently go at that speed, I would suggest you consult with a repair shop.Probably there is something loose. If you frequently go at that speed, I would suggest you consult with a repair shop.
