answersLogoWhite

0


Best Answer

That depends entirely on what happened to it to make it need repairing.

User Avatar

Wiki User

10y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you repair the wiring harness to the knock sensor for your 98 subaru legacy outback?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Where is 2001 Subaru Outback vehicle speed sensor?

See the Haynes Repair manual for Legacy & Forester 2000 thru 2006 on page 6-20 section 19.


Where is the crank sensor on my 1996 Subaru Outback legacy?

Directly below the alternator on the block.


Where is the oxygen sensor on a 2000 outback legacy?

It's underneath your car. Off the exhaust pipe.


Where is the Knock Sensor located in a 2000 Subaru Outback Legacy?

It is located on the engine block drivers side.


Where the coolant temperature sensor located in 1996 subaru legacy outback?

http://www.lovehorsepower.com/SubaruDocs/CoolantTempSensor.htmlits a 1995 but same thing


Where is the oxygen sensor located on your 1999 Subaru legacy outback sport utility sedan?

I just purchased new catalytic converters for my 1999 Subaru Legacy Outback. There are three ports for oxygen sensors. They appear to be on the top of the converters. I just purchased new catalytic converters for my 1999 Subaru Legacy Outback. There are three ports for oxygen sensors. They appear to be on the top of the converters.


Where is the oxygen sensor on a 1990 Subaru Legacy?

Oxygen sensor on 1990 Subaru Legacy is under car, just behind engine where exhaust manifolds join but before catalytic converter. Wires run up right side of bellhousing and connect into wiring harness.


Where is the knock sensor on a 98 subaru legacy outback?

Looking at the top of the motor remove the air intake and it is below the butterfly on the drivers side top end of the motor.


How do I repair a Jeep error code 121?

There are a few reasons for a Jeep error code 121. Some of the causes are a bad connection with the TPS, a corroded sensor, or a harness is rubbing a harness.


How do you change the knock sensor on a 1998 Subaru Legacy Outback?

Its on top of the engine by the fuel injection (remove the air intake first). Need a 10mm socket with a long extention.


2002 Subaru legacy outback code P 1137?

P1137: Front O2(oxygen) aka A/F(air/fuel) Sensor Circuit Range/Performance Problem.


Where is bank2 sensor 1 for Subaru outback h6 3.0?

Where is the bank2 sensor 1 located on a 2001 subaru outback 3.0