Depends. That system is a real bear. IF you have a battery that is 'suspect' in any way, you need to replace it with a quality battery. the security module will dump into 'security' status when the voltage drops during crank over. A healthy battery is really important on this system. Also, check the door entry key switches AND the tailgate switch which is a magnetic proximity switch as opposed to the front door microswitches that hang on the entry key cylinder tails. Next, check or just disconnect the hood security plunger switch near the battery. The possibility exists that the overhead console is contributing to your problem as it is wired to the security module. I have a 92 Cherokee and have been holding my breath for 5 years that it continues to run. I had an infrared security key built by a firm I found online. The Jeep came without one. as the front door lock switches had failed and I got tired of unlocking the system at the tailgate, I wanted a normal way to unlock the doors and disarm the security system. Good luck on your problem.
where is the security system located on a 1996 jeep grand Cherokee
There never was a 1974 Jeep Grand Cherokee.
form_title=Security System Repair form_header=6443 What issues are you experiencing with your security system?*=  False alarm  Faulty window or door security  Entry key pad isn't working  Want to change programming or codes  Want to expand my system  Other What contractor installed the system for you?*= () Professional () Consumer () Don't Know
Removing the security system of a 1993 Jeep Grand Cherokee can be done in less than 30 minutes. You will need to take out the Vehicle Theft Security System Module and all sensors. Make sure the battery is disconnected before removing.
A full time system was optional.
turn the key in the door lock
You can't, it is part of the body computer.
If it is a factory (OEM)security system. Go to passenger door and lock/unlock 2 times to clear/reset fact security system. If your battery is weak or toast you need to replace or problem will continue .
Lock the drivers side door with the key, then unlock.
Put the key in the driver's door (from the outside), and unlock the door. That resets the security system.
There is a plug in "black box" under your dash that can be unplugged to totally disable the alarm system. The remote clicker should still work but the factory alarm will not. Nothing else will be affected. You'll have to get a flashlight and look under there but the box in question does have a sticker on it that clearly says "alarm/security" on it.
turn the lock of back door twice, this resets alarm.
hey mate i have a 1997 jeep grand Cherokee and had the same problem.. its your idle sensor.. all i did to fix it was disconnected the battery for 30 mins.. i already did that, she will not turn over Did you shut off the security system by using the key or the remote? The engine will not run as long as the security is triggered.
pull it out of the box to bypass the centrifuge
use key to lock and lock driver side door
yes, there is a relay. And a fuse too.
The factory alarm system can not be disabled or bypassed. Any failure would need repaired.
Auto shut off?? You mean security system?Tell me the symptoms and ill answr. 20yr jeep/chrysler service manager. There is a relay under the hood that cuts spark called an IOD relay. Reset the sec system at the pass door by lock/unlock 3x
no bypassing,you need to repair whats broken. sorry.
A Security Patch
Passlock security system needs repair - gm dealer only as reprograming is part of the fix
It is an integral part of the computer system and can not be removed.It is an integral part of the computer system and can not be removed.
There isn't any sort of posi traction/ limited slip system in the rear axle.
passlock system needs repair, tow it to a GM dealer. They usually replace the lock cylinder & reprogram the security system. $500.oo-$600.00
You reset the alarm by unlocking the doors with a key. A 1995 Jeep does not have a reset button.