open the tailgate you will see 2 screws holding the assembly in place, uncrew, jiggle a little and it's out. very easy to do open the tailgate you will see 2 screws holding the assembly in place, uncrew, jiggle a little and it's out. very easy to do
How do you reset 2008 honda element service light?
The shifter light on the center console of a 1999 Honda Civic can be reached by removing the center console assembly. Loosen all of the proper screws and pull off the assembly. Once the bulb is visible replace the unit using an appropriate sized bulb.
the srs system is faulty due to a bad seat belt buckle. take your element to the dealer and have them replace it. there is no charge for this service.
Most of the time you don’t have to change the whole assembly, unless its been crushed or broken. The light bulb twists and un screws from the back of the assembly unit.
open hood to car. as u r facing the car there is a screw that holds the parking light assembly just above the headlight. unscrew the screw and the assembly slides right out. turn the burnt out bulb counter clockwise and replace it.after replacing just do the opposite to replace.
You can't reset that light...there is no such thing as a 2002 Honda Element...they didn't come out until 2003.
How do you replace the rear brake light bulb on a 2001 Honda civic?"
On a 2012 toyota Highlander, How do you replace tail light Assembly
How to replace passenger side head light bulbs in a 2000 Honda Accord?
05+ Honda Odyssey license plate lights. Pop out the license plate lights in the rear. There are two of them. Use a very thin flathead screw driver and pop out the sides of the inner clear light assembly. They are on the sides. Once that is done, remove the light bulb and replace with a new bulb. Pop in the clear light assembly cover. Turn on lights to see if the bulb is working and it is is then you're done. Approximately 10-15 minutes total.
One way to reset a 2005 Honda Element check engine light is to disconnect the battery. The battery will need to be disconnected for about 5 minutes for the light to reset.
Open the trunk twist the knob on the plastic cover and remove the cover. Twist the bulb socket out of the assembly, twist the bulb out and replace with the new, and reverse the process.