it would be easiest to get a O2 sensor socket to remove it, they are located on the exhaust pipe itself, not far at all past the engine, i cant tell you how many you need but if you look and count them that would tell you that (if you cant get a O2 socket you could get it with a wrench, or sometimes a regular deep socket)
On top of the rear axle. This is from pictures I've seen from guy that replaced their own sensors.
Where is the fuel pump located on a 1985 jeep cherokee
The Haynes Jeep Cherokee 1984 - 1996 book has 7 different diagrams which show how to do that repair.
How do you replace the safety neutral switch on a 1995 Jeep Cherokee 5-speed transmission and Where is the safety neutral switch located?
Check the abs sensor on the rear axel first and then the sensors on the front wheels. All of the sensors are rather expensive to replace. This is pretty much a dealer fix.
Never heard of Battery Temp Sensors. What exactly is the code #?
How to replace spark plugs in a 1989 jeep cherokee?
By a Haynes Manual at your local part store. The procedure w/ pictures will be in there.
there are 2 sensors on this model one located on the fron pipe and one on top of the manifold you replace them both the same disconect the sensors wire and it will be a 22 or 24 mm nut replace the same way as you took it out.
Need a special socket. They are located in the exaust manifold(s).
The TPS is located on the right hand side of the engine on the throttle body that has the large air intake tupe attached to in on top of the intake manifold. There are three sensors attached to the throttle body...the sensor located closest to the valve cover is the Idle Control Valve, the sensor in the middle is the TPS you want to replace, and the square plastic sensor nearest the fender is the MAP sensor. You will need a small torx bit to remove the TPS sensor. Changing it is simple and straightforward. Good Luck!
To replace a turn signal on a 1994 Jeep Grand Cherokee prop the hood open. Locate the headlight housing and the turn signal will be located next to it. Find the bulb and remove it from the housing. Replace the bulb.