0
How do you replace a 1999 Oldsmobile Silhouette front axle bearing and hub assembly sensor?
Wiki User
∙ 16y ago
First remove wheel and brake caliper and rotor.
Unplug wheel speed sensor wire.
Remove axle nut.
Remove three 1/2 inch head bolts from back side of spindle.
Gently tap hub to remove hub/bearing assy. from spindle.
Installation is the reverse.
Wiki User
∙ 16y ago
Add your answer:
Earn +20 pts
How do you replace a rack and pinion assembly on a 1997 Oldsmobile Silhouette?
Gm had a recall on this. Take it to a dealer to do it for free.
How do you replace the fuel filter on a 1999 Oldsmobile silhouette?
replace a fuel filter on a 1999 Oldsmobile Silhouette
How do you replace the headlight in a 2003 Oldsmobile Silhouette?
how do i replace the drivers side headlight in a 2003 oldsmobile silhoutte
How do you change the wheel bolts on a Oldsmobile regency 98?
you have to replace the wheel bearing hub assembly look up a picture and you will see the bolts are attached to the hub assembly.
How do you replace a leaky heater hose in your silhouette?
How to replace a heater hose on a 2001 Oldsmobile silloute
What happens if your Oldsmobile silhouette has the lower intake crack?
replace lower intake
How do you adjust power window tracking on a 99 Oldsmobile silhouette?
you don't you replace it
How do you replace a wheel berring on an Oldsmobile regency 98?
how do you replace a wheel bearing on an 1985 oldsmobile regency 98
How do you replace a power steering pump on 2001 Oldsmobile Silhouette?
a wrench and a 12 pack
What does it cost to replace head gaskets on 1997 Oldsmobile Silhouette?
I have a 2002 Olds Silhouette and had to replace the head gasket set 2 years ago. It raun around $1,700.00
How do you replace a wheel berring on an 1985 Oldsmobile regency 98?
how do you replace a wheel bearing on an 1985 oldsmobile regency 98
How do you replace the front turn signal bulb in a 1999 Oldsmobile Silhouette?
you have to remove the whole headlamp assembly to get to the turn signal bulb pull the headlight assembly straight out it is fairly easy There are two wing nuts on top of the unit that must be removed.
