I would think you arereferring to the drive belt. First thing to do is remove the mowing deck. From there you will find a spring lever that holds the belt tight. You will need to take a bar or wrench and release the tension on the belt and take the belt off of that pulley. Then from there it is a matter of loosening the pulley next to the frame and snaking the belt from around all the other pulleys in order to get it off. To install just do everything in reverse. In order to gain access to every thing it is best to stand the mower up on the rear wheels, you will need someone to hold the tractor in this position while you remove and install the drive belt. Just recently done this and the job is not really to hard. Just take your time as to not remove unnecessary components. You will have to loosen some of the pulleys but none have to be removed as I remember.
they only made the LT133 from 1998-2001
The correct one.
.040 thousandths
how do I remove the seat bracket from a lt133 john deere mower
pull the plug
Lt133 lawn tractor will not fire is coil bad
12 volts / 160 cold cranking amps
The John Deere 8345r has an ivt transmission.
The deck must be slipped beneath the machine from the left, the lift lever locked down and the rear hangers and front hanger plate attached. The belt will take take a 90 degree twist with the front part to the left side.
John Deere 450H Dozer hydralic transmission how can drain
how to replace battery in z425 zero turn john deere mower
john deere 950