It has a bolt at the center of it' BE AWARE that this bolt is reversed threaded, that means the direction normally used (right, is counter clockwise) to loosen , and left is "clockwise"to tighten, therefor when removing the bolt you go in the direction of tightening to remove it, the reason for this application is that the bolt is used to releive the tension on the serpentene belt to take it off for replacement.
You have to unscrew the tensioner bolt and remove the serpentine belt first, then change the pulley and replace the belt.You have to unscrew the tensioner bolt and remove the serpentine belt first, then change the pulley and replace the belt.
Since There is no tensioner pulley you have to loosen your alternator.
You will need to loosen the tensioner pulley. When the tensioner pulley is loose the air conditioning compressor belt will become loose. Put the new belt on and tighten the tensioner pulley.
You will need to loosen the alternator belt with the tensioner pulley. When the tensioner pulley is loose the alternator belt will become loose. Put the new alternator belt on and tighten the tensioner pulley.
You can replace the transmission belt, on a Cub Cadet 1042, by loosening the tensioner pulley. Once the tensioner pulley is loose the belt will easily come off.
Loosen the tensioner pulley. The serpentine belt will become loose and can be removed. Put the new serpentine belt on and tighten the tensioner pulley.
If it is a serpentine belt you replace the tensioner pulley
The serpentine belt you can look at the diagram in your engine compartment for actual routing. The tensioner mounts to the left side of the engine. You need to unbolt the whole assembly. Actually, the belt can be loosened by tightening the bolt of the tensioner pulley. When fully tightened, the pulley will act as a swivel.
Loosen the tensioner pulley on your Monte Carlo 3.1 liter engine. Slide the tensioner pulley to the right. The serpentine belt can be removed. Put the new serpentine belt on and slide the tensioner pulley to the left.
You can replace the belt, on your Ranch King lawnmower by loosening the tensioner pulley. Loosening the tensioner pulley will create slack in the belt.
You will need to loosen the tensioner pulley. Slide the tensioner pulley to the right and the serpentine belt will become loose. Remove the old serpentine belt and put the new serpentine belt on. Slide the tensioner pulley to the left and tighten it.
It should have an tensioner pulley on it. A spring loaded arm that puts pressure against the belt as it travels. You may need to replace the pulley and spring if it is failing and allowing the belt to slip off.