remove axle nut, remove lower ball joint nut and separate, remove wishbone bolt at lower control arm. pull 4 wheel bearing bolts on back side of spindal if present if not pull strut assembly away from axle, if axle stuck in hub carefuly drive axle out of hub. after separated pry axle out of transaxle with a screw driver. reinstall new axle careful to engauge c clip located on trans axle end. reassemble the rest and make sure to tourque the axle nut to factory specs.
Hoy do u time a honda accord
Listen to your father: go to the nearest public library and get a Honda manual--it will describe everything in detail!
A crank shaft position sensor on a 1998 Honda Accord reads whether or not a the engine is spinning correctly. If there is a discrepancy on how the crankshaft is spinning the sensor will relay it to the ECU.
timing marks on a Honda accord lx 2.3 year 2000 specifically the counter balance shaft
You have to replace the whole drive shaft.
No. The flex plate is on the transmission input shaft between engine and transmission. To get it out you have to pull the transmission. Fortunately, it's not hard to do.
which direction does a crank shaft pully bolt screw out on a 2002 honda accord lx 2.3l eng. clockwise or counterclockwise?
In some Honda's, you have to pull the axle shaft in. That may mean some disassmbly of the front end.
The 1992 Honda Accord is an interference engine. Replace the cam belt every 90,000 miles. The balance shaft belt should also be replaced at the same time. You should also replace the water pump which is driven by the cam belt. If the belt breaks you will have serious internal engine damage so do not neglect this maintenance.
The distributor assembly on a Honda Accord sends a spark to each engine cylinder at precise moments throughout the combustion cycle. It is controlled by the rotation of the cam shaft.
It is located behind the timing belt.
Depending on the engine, some have a timing belt and a balance shaft belt.