0
Can you replace a universal joint in a 2003 Honda CR-V or do you have to replace the whole drive shaft?
Wiki User
∙ 16y ago
You have to replace the whole drive shaft.
Wiki User
∙ 16y ago
Add your answer:
Earn +20 pts
How do you replace a Honda CR-V drive shaft universal joint?
drive universal jount
How do you replace a universal-joint on 1997 pickup 2-wheel drive?
with a u-joint press or c-clamp, there is a procedure, consult a repair manual, probably at your local library.
What is a huge joint?
You probably mean U - joint (universal joint)! Located at each end of drive shaft or axle and possibly in the middle of drive shaft.
Allwheel drive mitsubuhi Montero clunk noise when you accelerate?
You most likely have a bad universal joint. This universal joint is located in the drive line of the vehicle and needs replaced as soon as possible.
How much does it cost to replace a cv joint in a 4 wheel drive?
How much does it cost to replace a cv joint on 4 wheel drive
How do you replace a u-joint in Honda CR-V?
You don't the crv uses cv joints on their axles.Another View: There ARE universal joints on the All-Wheel-Drive models of the CR-V. They are what allow the power to be transferred from the transmission to to the rear differential to transfer power to the rear wheels
How do you replace a cv joint in a Honda Odyssey?
Much better to replace the whole axle, look at www.happywrenching.com for a guide on how to replace an axle in a Honda Odyssey
What is a huge?
You probably mean U - joint (universal joint)! Located at each end of drive shaft or axle and possibly in the middle of drive shaft.
How do you replace a cv joint on a 2000 Subaru Outback?
how do you replace the drivers side drive shaft and cv joint?
What does the universal joint on the propeller shaft of an automobile function?
The universal joint is used to transfer drive (power) from one shaft to another when they are inclined (non collinear) to each other.
How do you replace a universal joint on a 1986 Nissan truck?
== == US built trucks use a Neapco 1-0430 to replace factory staked-in joints on 4 cylinder models. Japan built 4 cylinders and V6 models use different ones, usually a Precision 369. == == you can't replace it you have go to a drive shaft company to replace it.. it's press on about $100 for both joint and balance drive.
Where can you find a universal joint?
On front engine/rear wheel drive cars there is always a universal joint on the drive shaft. If your looking to buy one, you could check with your dealer's parts department. They either will have one, or can order you one.
