Under the Driver Side (DS) dash on the left side near the fuse box you will see the flasher pluged in near the fire wall. The Flasher is tan, and is about 1" X 3" and 3" deep. This flasher is a duel unit, meaning that the blinkers and hazards are in the same part. It is a dealer only item and costs aroun $70 - $80. I would recomend going to a Pick-N-Pull to get a new one.
on a Mazda 626 there is a fuel pump relay check to see if you have a power signal from the relay to the pump, if so make sure there is power to the pump.
No, they are to totaly different cars. The RX-7 has a Rotary engine so 99% of the parts are going to be different than any other car on the market.
It takes alot of man hours and a few tools. Try a "Haynes Car Manual for your car from Autozone. It will give you step by step instructions
The flasher unit is behind the dashboard fuse box , need a torch to locate it . the flasher unit is a pale green colour rectangle box 65mm x 30mm x 30mm and is pluged into a small board with other plugs . There is a small tab above the flasher that you need to press down and then pull (very difficult in tight space). hope this helps good luck.
where is the EGR valve on a 1989 mazda b2200
I believe the 87 had a pull up type switch on top of the steering column.
a Mikuni solex 2bbl
87 #-ft
The signal flasher on a 1987 Acura Legend is located under the fuse box. This is on the driver's side under the dashboard.
First, you remove the fuse cover under the dash on the driver's side. Then read up and behind the fuse block and you will find it dangling on its' plug. You should be able to pull it around the fuse block out where you can easily remove the flasher and replace it with a new one. An additional comment -- On an 85 model, the flasher is clipped to the top of the ashtray casing, not dangling free.
There are none...i have an 87, short cab and there are no drain holes.
both are done much the same way.just make sure all torque settings etc are for whichever car you are working on