Firstly you need to remove the fuel tank. Then you will be able to see the top of the fuel pump and remove it. Service repair manuals start from $20 on eBay, and are a must if you have little or no knowledge of your car.
The Fuel Pump in a VT is located in the Fuel tank, as in most cars. I think you need to remove the fuel tank to replace, obviously great care needs to be taken.
And what is a Vt?
That sounds about right on this vehicle. It is a very difficult job.
IT COULD BE THE CRANK ANGLE SENSOR OR THE IN TANK FUEL PUMP
how much to get brake pads and rotors replaced on a holden vt commodore
Open the fuel filler door and remove the gas cap. Listen at the fuel filler opening while a helper turns the ignition on but does not start the engine. The pump will run for a few seconds and then shut off. If you do not hear the pump check the fuel pump fuse and the fuel pump relay. If they are good then the pump is more than likely defective. If you hear the pump then you know it is running but that does not mean it is pumping fuel. A fuel pressure test will verify the condition of the pump. Be sure and replace the fuel filter.
Replacing a head gasket on a VT Commodore instructions can be found in a manual. Manuals can be bought at most auto parts retailers or in book stores.
Holden VT Commodore was created in 1997.
YES, DO NOT REMOVE IT (Unless it is to replace a broken one)
http://forums.justcommodores.com.au/holden-commodore-how-tos/5541-removing-vt-vx-door-trim.html
the fuel pump tank wiring is faulty at the pump
in the tank. The tank needs to be removed from the bottom of the vehicle. If you haven't done one before I would get a mechanic to do it, as the clips and hoses are easy to break.