you need to unbolt the front plate of the dash ,, then theres a cover on the heater core , that needs to be removed , then the heater core is bolted up there and , should come right out after unclamping hose ( located on the outer firewall-- under the steering rack, . kinda tricky to get back into position but it can be done . after back in , just re-install all plates and covers -DONE
how to replace a heater core in a 1997 Chevy blazer
.the heater core is behind the dash .
How do i change the heater core on a 1997 ford e150
where is the heater core at
How to change a heater core on a 1997 Pontiac grand am
You can replace the sheer core, on your 2004 Pontiac Grand Prix, by removing the water lines. Remove the four bolts that hold the heater core in place. Reverse the process to install the new heater core.
The dash has to be removed to gain access to the heater box. The heater box then comes out and is split open to replace the core.
It is cheaper to replace the heater core than it is repair it
Easy to replace. Hard to get to.
The heater core is located in the middle of the dash behind the center console. You have to take the console out to see the heater core.
take it to the dealer
How do you replace the heater core on a jimmy?
You will need to remove the anti-freeze from your 1997 Chevrolet Venture cooling system. Remove the water lines from the heater core. Remove the heater core retaining bolts. Reverse the process to install the new heater core.
remove the entire dash
You hav to put it on top
you might be able to just go through the back of the glovebox to get to the heater core
Around $500. $450 in labor and the heater core is about $50. PITA job!
how do u replace the heater core
It's tough for an amateur. The heater core is inside behind the console.
The heater matrix, in a Peugeot 206, can be replaced by removing the heater core and the hoses. With the heater core removed you can replace it with a new heater core.
well usually the heater coil would be on the pass side firewall you would have to take that side of dash out were your glovebox is and then you can unbolt and disconnect it and install new one
Drain the radiator. Remove the heater hoses from the fittings at the firewall under the hood. Loosen the dash, and pull it out enough to reach under to the heater core. unbolt the core, remove, then replace. Reverse the procedures to finish the installation.
How do you remove the heater core on a 1997 Toyata Corolla?
get a chilton guide book