Pull of the plenum and all hoses connecting too and mark all hoses your not sure about like vacuum hoses. Now unbolt the intake off the engine and u will see a sending unit looking thing in the base of the engine leading down toward the engine. Unscrew the old knock sensor out and replace with a new one. Put everything back on reverse order. be sure to install a new intake gasket when your in the engine.
89 toyota pickup v6 engine anti knock sensor location
Unless you are skilled in working with engines, I would advise you to bring it to a mechanic. If you are, get either a Hayes or Toyota manuel and go step by step to taking apart your engine. The knock sensor is in the exact middle of the engine.
engine bay
the knock sensor is located on the driver side of the engine right under the intake it is about 1 in. it is connected so you will have to unplug it and then just screw it off
If you have the 7MGE engine: Then the knock sensor is screwed into the engine block, directly underneath the intake manifold.
Knock sensor is attached to the engine side facing the firewall. It's not easy to reach.
Open the hood
replace it.
There's no need to replace knock sensors, and there was never a 3.6 engine.
You need to test/replace the knock sensor. ireplaced it already.
Knock sensor is located in the wall of the engine block facing the firewall. You have lift the car if you want to reach it.
how many gaskets and which ones are needed when you replace the knock sensor on a Nissan frontier w/a 3.3l v6 engine?