The Knock sensor is located on the lower side of the engine near the oil pan rail and goes into water. Make sure your engine is cool before you start the job. The best way is to drain all of the coolant out of the engine first, then disconnect the wire, then remove the knock sensor. WARNING--antifreeze will come pouring out when you take the knock sensor our so WEAR SAFETY GOGGLES to protect your eyes.
Do not use any sealer other that the sealer that is on the new sensor.
how do you change the knock sensor in a 2003 Chevy silverado 5.3
how do I disconnect the Electrical connection on knock sensor
under the intake manifold
under the dome
I found in a google search 15ftlbs torque for the knock sensor.
how to replace a knock sensor on a 2000 Chevy 6.0 step by step
you have to pull off the intake they are under there. you have two you might as well replace both
$300.00
Under the intake manifold there are 2 knock sensors
NO.
Under the intake manifold.
The knock sensor is located on top of the block in a 4.8 2002 engine. The intake will have to be removed to get to the sensor.