Ford Windstar
Ford Windstar SE
Ford Escape XLT

How do you replace a lug bolt on the front axle of a 1998 Ford Windstar?

161718

Top Answer
User Avatar
Wiki User
2015-07-15 21:49:14
2015-07-15 21:49:14

I replaced a lug bolt on a Ranger a few years ago. I took a small sledge hammer and "tapped" it back through the hole. (the opposite way that it is tightened) Make sure nothing is behind it. Oh yeah I did have to remove the caliper and brake roter first.

The majority of Windstars have a wheel bearing / hub assembly. To replace a broken lug (if possible) is going to require the hub to come out.

See "Related Questions" below for information on these procedures.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

Replace freeze plug in a 1998 ford windstar ?

User Avatar

On a 1998 Ford Windstar ( 3.0 and 3.8 ) firewall 1-----2-----3 4-----5-----6 front of vehicle > driver

User Avatar

A 1998 Ford Windstar would use refrigerant 134a

User Avatar

YES , the Ford Windstar is a front wheel drive vehicle

User Avatar

Autozone.com has an illustrated repair guide for the 1995-1998 Windstar on-line! See link below under "Related Links"

User Avatar

ask an automobile expert and please answer the qu were the evaporator is P.S. not my qu

User Avatar

On a 1998 Ford Windstar : The 3.8 liter V6 engine ( and the 3.0 ) has a timing CHAIN

User Avatar

Windstar mini-vans are front wheel drive.

User Avatar

On a 1998 Ford Windstar ( 3.0 and 3.8 ) firewall 1-----2-----3 4-----5-----6 front of vehicle > driver

User Avatar

On a 1998 Ford Windstar : ( # 16 / 20 amp )

User Avatar

Not likely - the 1999 Windstar was a rather significant updating of design compared to 1995-1998 models.

User Avatar

where can i buy a side window for my 99 ford windstar lx

User Avatar

I don't know how to do it, but the dealer is charging me $2075.00 to replace it on my 2000 Windstar!

User Avatar

On a 1998 Ford Windstar , 3.8 ( and 3.0 ) liter V6 engine : firewall 1-----2-----3 4-----5-----6 front of vehicle > driver

User Avatar

I am looking around to replace the transmission on my 1995 Ford Windstar and the information that I received from several different mechanics is that the 1995 Windstar transmission is a "one year" transmission so you pretty much have to get a 1995 transmission for a 1995 windstar engine. I'm no mechanic and really have no idea but this is just what I've been told... someone out!

User Avatar

Reverse backwards and hit a boulder.. that thing will rip right off!

User Avatar

Yes, 6 cylinder engine has three in front of the engine and three in the back - by the firewall - that are difficult to get to.

User Avatar

The block heater plug in on a 1998 Ford Windstar is in the engine compartment on the passenger side of the vehicle. When lifting up the hood, look on the left for a small hose that is coiled up at the very front, above the passenger headlamp. The block heater itself is plugged into the front of the motor on the passenger side.

User Avatar

On the underside of the engine.

User Avatar

Mostly in the Windstar category - they all apply to the GL model

User Avatar

It's # 28 , a 20 amp fuse for the front cigarette lighter

User Avatar

The Windstar, Freestar & Monterey are Ford's front-wheel drive mini-vans. The 'Econoline' series of vans and Aerostar are the rear-wheel drive offerings.

User Avatar

In a 1998 Ford Windstar : There were 2 engine sizes offered from the factory : A 3.0 liter V6 engine and the 3.8 liter V6 engine

User Avatar

Follow the LOWER radiator hose from the radiator . It connects to the water pump on the engine on a 1998 Ford Windstar


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.