if you have the steering wheel removed remove torx bolt thru bottom of cover,slide assembly out,be sure not to rotate the clockspring, remove 3 torx bolts,slide out,turn assembly over remove 3 srews Phillips heads ,slide plastic housing off back, remove module by sliding off assembly, remove Phillips on front to remove steering angle sensor and the multifunction switch is all that's left, hope this helps,can email me at jpstets1@AOL.com if need be.i am an ase certified master tech in VA.
see section 19 of ur owners manual.
Remove the plastic shielding from around the steering column, unplug the multifunction switch, remove the bolts used to mount the multifunction switch. Installation is the opposite of reverse
Bulb is probably defective. Replace it.
Remove the tilt steering lever.Remove the steering column cover.Unplug the wire going to the switch.Now you can remove the bolts that hold the switch to the column.An instructional video of how to remove the multifunction switch on a 1993-1997 Dodge Intrepid has been included below.
yes, replace the switch
Check the fluid first
I quess is that the spring plunger that is behind your horn button is defective. Remove the steering wheel to replace it.
remove the positive cable under the hood instead of removing the cable from the battery, then take off the top cover and bottom after that get a 4 prong screwdriver, at the top take off the 2 screws and last unplug the connectors finally pull off the multifunction switch off.
== ==
You have to remove the top and side covers on the steering wheel column, remove I think 4 screws-bolts, disconnect the wire connection, and remove the old switch.
i have a 300zx Nissan and i need to replace themultifunction switch i don't know how?
I would suggest buying the parts and repairs manual for the vehicle. It will tell you how bolt by bolt.