Best Answer

Remove rad shroud, remove fan clutch, remove trans cooler lines, ( use a flare nut wrench to avoid stripping the hex) remove the rad brackets then top and lower hose ends. Reverse.Make sure to fill and bleed the cooling system when done. Run vehicle at idle for 30 minutes with the rad cap off to bleed air out of system.

User Avatar

Wiki User

โˆ™ 2006-02-25 17:22:18
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you replace a radiator on a 2000 Chevy S-10 2.2 liter?
Write your answer...
Related questions

How do you replace a 2000 Honda Odyssey radiator?

how do you replace a 2000 handa odyssey radiator

How do you install a radiator 2000 mercury mystique 2.0 liter engine?

There are 11 steps on how to change a radiator in a 2000 Mercury Mystique 2.0 liter engine. Some of the step-by-step instructions are to first squeeze the hoses to check for deterioration, if the hoses are swollen replace them, and then replace the hose clamps.

What are radiator bearings on a 2000 Chevy Malibu?

no such thing !

How do you replace radiator 2000 Chevy Astro Van?

Replaced radiator in 2ooo astro cargo van with new one from auto parts wharehouse now oil cooler lines leak at radiator whats wrong

How do you replace thermostat in a 2000 Chevy Express van?

Drain the vans radiator. Remove the top radiator hose and water inlet. take the thermostat out. Put in the new thermostat and re install the inlet and hose. Refill the radiator.

Where are the airbag sensors located on 2000 Chevy impala?

On radiator

Where is the drain plug for the radiator in a 2000 Chevy Malibu?

AnswerLook at the bottom or rear of radiatorit is on the front right of radiator!!on bottom.

How do you replace the front driver side seat belt on a 2000 Chevy Blazer?

how do you replace seatbelt retractor on a 2000 chevy blazer

How do you replace a radiator on a 2000 wind star?

you dont

What are the torque specs for a 2000 Chevy Impala 3.8 liter?

What are the torque specs for 2000 Chevy Impala 3.8 Litre ?

Where is the radiator located in a 2000 Chevy Malibu?

radiator is in front off the cooling fans ,in the front of engine.

Where is the Chevy Prizm 2000 cabin air filter?

inside the radiator,but you need to change when the radiator is to hot.ok.

How do you replace a knock sensor on a 2000 Chevy 6.0 step by step?

how to replace a knock sensor on a 2000 Chevy 6.0 step by step

How do you find the thermo sate on a Chevy Blazer 2000?

Open the hood, locate upper radiator hose, follow the upper radiator hose from the radiator to the "gooseneck" located on the engine, the thermostat is located under the "gooseneck". The "gooseneck" has to be removed to replace thermostat.

How do you replace a 2000 Chevy Malibu door lock actuator?

how to replace actuator on a 2000 malibu

Where is he radiator drain plug on a 2000 Chevy Monte Carlo SS?

It is just beneath the lower radiator hose.

Will a 4.3 liter engine from a 2000 s10 Chevy blazer fit a 1997 s10 Chevy blazer that also has a 4.3 liter engine?


How many hours does it take to change radiator in Chevy Venture?

The book time, or time it takes a mechanic,Êto change a radiator in a 2000 Chevy Venture with the 3.4 liter engine is 3.1 hours. It may take slightly a longer or shorter time depending on the exact vehicle year and engine size.

How do you flush radiator in Chevy Malibu 2000?

Buy a new car its a pos

Will a radiator from a 1999 Chevy Malibu fit a 2000 Chevy Malibu LS?

Yes. '99-'01 same

What radiator cap for 350 Chevy?

According to the Haynes repair manual for Chevy/GMC trucks 1988 thru 2000 the cap should be a 15 psi radiator cap.

How do you replace the EGR on a Chevy Tracker?

repair timing chain on 2000 chevy tracker

How many psi is the radiator cap for a 5.9 liter 2000 dodge durango?

16 psi

How do you replace a thermostat on a 2000 Ford F-250 V10?

To replace a thermostat on a 2000 Ford F-250 V10, drain the radiator. Locate the thermostat on the top hose assembly and remove the screw. Replace the thermostat and refill the radiator.

2000 Chevy silverado spark plug gap for a 4.8 liter?