Mercury Grand Marquis
Radio

How do you replace a radio on a 1984 Mercury Grand Marquis?

545556

Top Answer
User Avatar
Wiki User
Answered
2015-07-15 19:20:30
2015-07-15 19:20:30

Hey Nicole==TAke the knobs off and remove the nuts under them then get under the dash and remove the wiring and any nuts holding the rear of the radio. GoodluckJoe

001
๐ŸŽƒ
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Related Questions


How do i set time on radio for a 2004 grand marquis


The stock amp in a 1990 Mercury Grand Marquis is in the dash behind the radio.


The factory radio on a 1987 Mercury Grand Marquis is made to play local radio states and cassette tapes. It is connected to a high fidelity sound system.




remove radio from a grand marquis 2003




You can buy a FORD radio removal kit at some auto supply stores.


How do I Replace light in 2000 grand prix radio?" This space is for answering "http://wiki.answers.com/Q/How_do_I_Replace_light_in_2000_grand_prix_radio"


you need radio tools,i found mine at walmart,they look like a big u,they come two to a pack, insert tools in holes beside radio,spread slightly toward outside with thumbs while pulling. I was able to do this on my 1995 model by cutting a wire clothes hanger and making two u-shaped horseshoe looking hooks. You can insert these into the holes on each side of the radio releasing the latches and you can ease the radio out. I used the tool, pushed it in, but the radio didn't come out. What am I doing wrong?


replace the radio fuse with the motor running, it'll reset the unit.


http://www.carstereohelp.com/stereoremovalMercuryGrandMarquis2.htm this link has great step by step instuctions on new radio install including removing the original.


Sounds like receiver ok, check the speakers/fuses.


not completely sure yet, trying now....possibly need to get a puller from parts store and put wires in 4 holes in the front of radio and pull once they clip into place.....otherwise may be able to push it out from the back once ashtray is removed....wire harness is easily removed from back of radio once the radio is out....good luck :)


Tie wraps can be used to replace a stock radio wiring harness in a 1991 Mercury Tracer. The wires can be replaced with other radio wire from an automotive parts store and the tie wrap can hold them together.


http://www.installdr.com/InstallDocs/FLM/Contour.html


Mercury Radio Arts's population is 120.


Mercury Radio Arts was created in 2011.


I owe a 2001 doged caravan sport my radio is not working properly after changed the altarnator


On my 95 Grand Marquis I had to pry off the woodgrain panels beneath the trim ring (I am assuming you are talking about the one surrounding the gauge cluster and radio) There were 5 7mm screws under them and 2 more at the top of the gauge cluster. Good Luck!


The duration of Mercury Radio Arts is 2 hours.


if the clock is not displaying that is light bulb you can buy on eBay or at a gm dealer.


Go down to the parts store or Wal-Mart and buy a radio puller. It is two horse shoe shaped wires with little notches on the ends. You put the pullers into the holes in the face of the radio. There should be two on the right and two on the left, above and below each other. Push them in until they lock in and then just pull out. You may have to spread the pullers toward the outside to get a good bite on the radio. Then, you just pull out and the radio slides out. Then unplug the wires from the back.


u could either find the diagram online like at google or ask.com and if it doesent show u one but it should go to auto zone or some good car place any questions email me at edwin_69@usa.com



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.