Depends on the type of rivet but most can be removed by drilling off the head with a larger size drill bit then pushing the rivet the rest of the way out. You will then need a rivet gun and appropiate size rivet to replace it.
you would have to drill out the existing rivet and replace with a larger one
If it is a rivet, then you must drill the old rivet out.
I am Pretty sure that if you look on the door in the down below the latch, there is a rivet... You have to drill the rivet off and that will free it. Then you have to unplug the connector at the bottom off it. Then take it out replace it and then re-rivet it to the door. This is explained after door panel is off, and vapor barrier is peeled back. It takes a "big daddy" rivet gun to put that big rivet in.
The rivet holding the old ball joint in place must first be drilled out. Use a punch and hammer to put a divit in the top of the rivet, drill a small hole then a larger hole through the rivet. Use a hammer and chisel to cut off the head of the rivet and then hammer out the rivet. The new ball joints are installed with small bolts.
I assume the rivet you are asking about is a "tinners" rivet and not a more common "blind" rivet (commonly known as a "pop" rivet). If this the case the tool you want is called a "rivet set".
upset -------------------------------------------------------------------------------- Upsetting the rivet is to compress the rivet during the installation process. That can be done with a rivet gun to "hammer" the rivet against a bucking bar, or to use a rivet squeezer to compress the rivet.
a rivet gun is a gun
A DD rivet is recognised by 2 dashes on the head of the rivet
The distance between rows of rivets from the center of the rivet to the other rivet in a pattern that is staggered.
To change brake light bulbs on a 1998 Lexus ES300, open the trunk lid. Locate the plastic rivet on the side of the trunk liner. Turn the rivet while pushing in with a screwdriver. Remove the rivet and the trunk liner can be pulled away to access the bulb. Push in and turn the bulb to remove. Insert the new bulb the same way. Replace the rivet in the trunk liner.
Élise Rivet was born in 1890.
Élise Rivet died in 1945.