0
How do you replace a slave cylinder and remove transmission on a manual 1988 Ford F150?
Wiki User
∙ 13y ago
Its going to depend on 4wd or 2wd .. Start by supporting the truck on a lift or jack-stands
then removing the drive shaft it should be 4 12m 12 point bolts,
then remove any wires, cables or lines attached to the transmission such as the speedo cable/wire, clutch lines ect
then support the transmission with a jack and remove the cross brace holding the transmission if it is 4wd you may find it easier to remove the transfer case as well
then remove the bolts starting at the top of the transmission, before removing the last bolt make sure the transmission is supported well and remove the last bolt
breaking the transmission from the block can be tough but a pry-bar or a sturdy flat blade screwdriver will do the job once removed the slave cylinder can be removed from inside the bell housing
Wiki User
∙ 13y ago
Add your answer:
Earn +20 pts
How to fix leak in front of manual transmission?
Remove transmission and replace front seal.
How do you remove and replace the clutch cylinder on a 1999 Chevy s-10?
To replace the slave cylinder on this vehicle you will have to remove the drive shaft and then the transmission. The slave cylinder will be bolted to the inside of the bellhousing. The transmission is very heavy so be very careful.
Slave cylinder jeep wrangler 87 how to replace?
Yo have to remove the transmission.
How do you replace slave cylinder tube without removing transmission?
It depends on where the slave cylinder is located. If it is inside the bell housing you will have to remove the transmission.
How do you replace 1989 jeep Comanche clutch slave cylinder?
Remove the transmission to excess the inturnal slave cylinder
How to replace slave cylinder Chevy cavalier 98?
This is not for beginners. You have to drain the transmission, remove the axles, remove the transmission, install the new cylinder, then replace the transmission, axles, add new synchromesh fluid to the tranny, and bleed the clutch hydraulics. You can get the whole procedure from Autozone's website.
Do you have to remove the slave cylinder from a 2004 f150 by removing the tansmision?
Yes , the slave cylinder for a HYDRAULIC clutch is inside the manual transmission bellhousing. It slides over the transmission input shaft and is bolted to the transmission
Do you have to remove transmission to replace slave cylinder in 1999 Chevy 4x4 z71?
YES you sure do.
How do you replace a clutch slave cylinder on a 1991 YJ Wrangler?
You will have to remove the transmission since the slave cylinder on the 91 yj is inside the bellhousing.
Do you have to remove transmission to replace slave cylinder on 5.7 1997 5 speed Chevy truck?
YES. It will have 3 bolts that hold it in place in the bell housing. Must remove transmission to service.
How do you change a clutch slave cylinder on a 1988 Chevy S10 Pickup?
You will need to remove the transmission to replace the clutch slave.
How do you replace the torque converter on a 2005 Dodge Grand Caravan?
You have to remove the transmission to replace the torque converter.You have to remove the transmission to replace the torque converter.
