0
This is not for beginners. You have to drain the transmission, remove the axles, remove the transmission, install the new cylinder, then replace the transmission, axles, add new synchromesh fluid to the tranny, and bleed the clutch hydraulics. You can get the whole procedure from Autozone's website.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
How do you replace the slave cylinder in 96 Chevy C1500?
How do you replace a slave cylinder in a 96 chevey k1500
How do you replace a cavalier slave cylinder?
You have to pull the tranny as it is located internally
Where is the clutch slave cylinder on Chevy 2003 cavalier?
Inside the bell housing, the transmission has to come out
Where is the slave cylinder located at in a 1999 Chevy cavalier?
I found the answers to a lot of my questions about my 99 Cavalier by buying a Chilton's manual for the car.
Where is the bleed valve on a 2.2 ecotec Chevy cavalier?
The clutch bleed valve on a 2.2 liter Chevy Ecotec engine is located on the slave cylinder. To find the slave cylinder remove the battery, as it is mounted underneath the battery tray.
Can you just replace the slave cylinder on a 1995 Chevy Cavalier?
Pull or cut the hose off the slave and master Cylinder.Go to the parts store and buy a long hose for a grease gun and a couple clamps. Clamp it on both ends and bleed it
Where is the slave cylinder located on a 2000 Chevy S10?
The slave cylinder is inside the trans. If you need to replace it you will have to pull the trans out. Its not that bad, its a afternoon though.
How do you change a clutch slave cylinder on a 1988 Chevy S10 Pickup?
You will need to remove the transmission to replace the clutch slave.
Do you have to remove transmission to replace slave cylinder in 1999 Chevy 4x4 z71?
YES you sure do.
How do you remove and replace the clutch cylinder on a 1999 Chevy s-10?
To replace the slave cylinder on this vehicle you will have to remove the drive shaft and then the transmission. The slave cylinder will be bolted to the inside of the bellhousing. The transmission is very heavy so be very careful.
On a 1996 Chevy Cavalier slave cylinder the stiff hose that comes out of the bottom how is this pulled out of the piece that enters the transmission?
If I am understanding the part you are talking about the. It is the metal line that goes into the slave cylinder that attaches to the rubber hose from the slave cylinder... Depending on your slave cylinder it is/was held in by a plastic horseshoe style clip that could have broke from a stress fracture manufacturer defect or overheating
Do you have to pull out the transmission to get to the slave cylinder in a 1997 Chevrolet Cavalier?
No
