it is right on the back of the engine you have to first unbolt the wire going into the back of it then there should be 2 bolts and it just slides out and then reverse the process to install its really not that bad
A good tip if your starter clicks but does not spin the motor (a most common starter failure). The starter solenoid is easily removed and opened once the starter has been removed from the car. It has a metalic disc inside which makes contact with two internal bolts as the solenoid is activated. These become charred and burned over a long time and can be sanded and cleaned to restore usage for several more years. This has has been a long used process on many other types of automobile starters.
without remove the air filter assembly, bolts are difficult to access.
i have toyota tercel i ned change the starter help please
The starter on a 1991 Toyota Tercel is located in the front of the engine. It will be located on the left side.
I dont think you could change the Transmission oil for the 1996 Toyota Tercel. Its sealed.
It is attached to the starter itself.Toyo joe
Check here for details: http://www.toyotaowners.net/toyota-forum/showthread.php?t=4012
Transmission fluid goes in the transmission of a Toyota Tercel as instructed by the manual for the vehicle. To know what is best to put in the vehicle, get advise from an auto part supplier.
Gear Oil [ SAE 75 W 90 & others] Transmission Fluid IS NOT USED in the 1996 Toyota Tercel.
Disconnect battery. Remove air filter assembly. Remove brace from intake manifold to engine block next to starter. Remove the two wires from the starter. Remove the two bolts holding the starter. One at the bottom the other at the top from the transmission side. The reason for removing the air filter assy.
Look at the bottom end of the engine
the starter should be under the intake on the back of the motor.
How to replace a starter in a 2009 toyota sienna
The starter on a '93 tercel, if you are looking from underneath the car, is directly to the left of the alternator. It is a fairly simple job to remove and replace the starter. If I can recall correctly the only thing that you need to remove is the intake support braket, but don't quote me on that.