Most people would say it can not be done. but if you don't minde playing around with the tail light, I think the Circuit board will come out with the back plate but it will take abit of work prising it off as it is glued on. But then you would have to get an used tail light that has broken lenses and good sockets
You can't. There's a circuit board connected to the shifter with LEDs on it. You have to replace the whole shifter. P/N # 52104149AC
It depends on what caused the device to not power on. The battery could be damaged. Replace the battery. The charging unit could be damaged. Replace the charging unit or find the damaged component and replace it. The charging connector could be damaged. Replace the circuit board or find the damaged component and replace it. The power button could be damaged. Replace the circuit board or find the damaged component and replace it. Something could have fried the circuit board. Replace the circuit board or find the damaged component and replace it.
the switch board could be bad.
The lights are soldered on the circuit board. You either have to purchase a new circuit board from the dealer(stupid!) or if you are handy with soldering, you can remove the bulb from the circuit board and replace with an aftermarket bulb.
You cannot do this. The CPU is permanently bonded to the main circuit board (the logic board). Apple techs would simply replace the logic board.
77070
It's the sensor for the keyless entry remote.
The main circuit board of the computer is the motherboard.
A soldering tool can be used to replace faulty components on the computers circuit board.
Open up the case and replace the B772 transistor on the circuit board.
== == We found it located in behind the right side of dash board, in behind the glove box. For our 1993 Jeep Grand Cherokee Laredo
rigid-flex circuit board