Chevy Blazer
Buick LeSabre
Nissan Pathfinder

How do you replace a wheel bearing on a 1994 Buick LeSabre?


Top Answer
User Avatar
Wiki User
2009-09-22 00:11:12
2009-09-22 00:11:12

Front or rear?

User Avatar

Related Questions

I have a shimmy or small vibration while driving the interstate on my 1994 buick lesabre - if i was to check the front and rear bearings - how would i do that and what would i look for

No they are not, 1985 is rear wheel drive & 86 on is front wheel drive.

The 2001 Lesabre may have a bad wheel bearing. Check the bearings for all four wheels for a bad bearing.

no need to replace wheel bearing unless the wheel bearing is worn out

It should be 118 ft/lbs of torque. I've also included a how to video in the related links section below, if you are unfamiliar with changing them.

How do I put a wheel bearing on with out a wheel bearing press

how to replace front wheel bearing on 1996 Hyundai elentra

You can replace the front wheel bearing, on your Kawasaki Mule 3010, by removing the axle. With the axle Remove the wheel bearing will slide off.

how do you replace the rear wheel bearing on a Chevy pick up

The 1998 Buick LeSabre custom sedan has a curb weight of 3,443 pounds. It has a wheel base of 110.8 inches and a ground clearance of 5.5 inches.

You can change the front wheel bearings on your 2000 Buick Regal without replacing the entire hub assembly. You can change each individual wheel bearing, if you choose.

Remove the tire and wheel from your 1992 Eagle. Remove the wheel bearing nut. Remove the wheel bearing and the wheel seal. Reverse the process to install the new wheel bearing.

Is the wheel bearing on the front or the rear ????.. There is a big difference ...

To replace the front wheel bearing on a Ford Fiesta, you will need to remove the wheel. Then with a hammer you can pull the old bearing out.

Hey Jennifer==TAke the wheel,caliper and rotor off then take the nut off of the axel. Then remove the 4 bolts that hold the bearing assy on and remove it and install a new one. GoodluckJoe

Struts on a 1998 Buick LeSabre are changed by jacking the vehicle up, removing the wheel, and unbolting the strut. It can then be pulled from its mounts and a new strut put in place.

Check your wheel bearings. Mine made a noise when turning right and had to replace the wheel bearings and hubs as they are all one unit on my 92.

The front wheel bearing is a sealed unit with the wheel hub - replace the hub and wheel bearing unit. Remove the four bolts from the rear of the steering knuckle that connect to the hub bearing unit.

Wheel bearing are what allow wheels to spin smoothing on an axle. A broken wheel bearing can lead to fatal car accidents. To replace a wheel bearing on a Volvo s80 remove the wheel hub and have the bearing pressed out. Press the new bearing into the wheel hub to ensure a safe install.

Remove the rear tire and wheel. Remove the axle end cap. Remove the wheel bearing seal. Remove the wheel bearing. Reverse the process to install the new wheel bearing.

Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.