How to replace wiper motor on a 1998 montero sport mitsubishi
replace the pulse board on wiper motor which is a black cover
The wiper motor on a 1998 Chevy Venture is up under the vents next to the windshield. It is bolted to the firewall.
If the wiper motor is good and the motor shaft turns when the wiper is on then you need to check the linkage for the wiper arm. the rear wiper motors and switches are notorious for going bad in the jgc you may have lost your switch.
Should be able to access under hood at center firewall plastic panel may have to be removed
Begin by removing the traveling arm retaining bolt from your 1998 Chevrolet Cavalier wiper motor. Remove the wiper motor retaining bolts. Remove the wiper motor wiring harness. Reverse the process to install your new wiper motor.
If the windshield wipers are not working in a 1998 Ford F150, the cause could be a blown fuse. There could also be a problem with the vacuum hoses connected to the wiper motor or the wiper motor itself.
Mounted on the firewall directly behind the brake master cylinder reservoir. UNDER WINDSHIELD WIPER COWL COVER remove the wiper arms remove the windshield wiper cowl cover disconnect the eletrical connector from the wiper motor and remove the motor remove the wiper motor retsining bolts pry the linkage arm off the wiper motor pin with large screwdriver
It is located right on the windshield washer reservoir. It looks like a short black cylinder.
Your wiper arms that run from the wiper motor to the windshield wipers may be binding and need to be replaced
Under the hood, on the firewall, drivers side.