Serpentine Belts
Pontiac Firebird
Ford Expedition XLT

How do you replace an accessory belt on a 1990 Pontiac Firebird and how do you verify that one of the pullies is not stuck?

194195196

Top Answer
User Avatar
Wiki User
2015-07-15 19:38:55
2015-07-15 19:38:55

take off the old belt and try to turn all the pulleys, all should turn freely except for the crankshaft, (the big one on the bottom)

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

HOW DO YOU GET THE LEFT TURN SIGNAL BULB OUT ON A 2000 PONTAIC FIREBIRD

User Avatar

You can replace the ignition lock cylinder in your 1994 Pontiac Firebird without removing the steering will. Remove the retaining ring at the top of the ignition cylinder. The ignition cylinder will slide out.

User Avatar

control module~! i had that problem i replace it and it runs like a dream!

User Avatar

The EGR Valve on a 1999 Pontiac Firebird is located just to the left of the engine oil dipstick. There's nothing in the way so it's pretty easy to get to and replace. Hope this helps! -Erin

User Avatar

This site has a step by step guide for an older Firebird, but it is identical to what you need for a 2001. http://shbox.com/page/windowmotor.html

User Avatar

yes but you will have to replace the computer with one from a v-8 car

User Avatar

drop the tank and take the old pump out then put the new one in

User Avatar

If it's a Pontiac 350......and it should be, it is a direct swap. You don't need to change ANYTHING. Pull the 350 out and put the 455 in.

User Avatar

raise the hatch pull down on the carpet, determine which light is out and twist to come out, you dont replace from the outside of the car!!!

User Avatar

i changed the one in my 87 firebird formula and i had to cut the filler neck in half then connected it back with a peice of hose if you don't want to do that i think you have to drop the rear end

User Avatar

Take the top radiator hose loose from the top of the engine. The thermostat is under there. just pry it off with a screwdriver.

User Avatar

inside of hatch on back wall separate carpet back a lil then theres black wing nuts on the tail lights remove them all and replace install is opp of teardown

User Avatar

take apart the thermostat housing and pop it out be sure and replace the gasket too. There should be two bolts holding it together.

User Avatar

factory recommendation is to cut a hole in the inner fender well to access/replace it.

User Avatar

The question you ask is too involved for a proper answer. You need to go to a car parts store, and get a repair manual for your car. They cost about $16.00

User Avatar

There are a hundred answers for that question on here. However, the easiest way is to remove the passenger side fender to gain access.

User Avatar

Replace Fuse Replace socket Replace element

User Avatar

Drop transmission oil pan- filter is held on by 2 short bolts - make sure you replace the "O" ring in the filter Clean pan Replace pan gasket

User Avatar

Remove the wiring from the top of the EGR then unbolt it at the bottom of the EGR system. You may need to replace the gasket after replacing the EGR itself

User Avatar

Pull out the old flasher (located under dash pannel above brake pedal, above the horn relay) and put in the new flasher.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.