What is the exact size of the engine (liters) and does it have AC. There are 2 models for that year. One of them was a GT. I can give you step by step instruction if I know the specifics. Thanks!
I have a 97 Ford probe and when I had to replace my alternator... I had to pulled the passenger tire off and pull the whole assembly apart so I could get the alternator.. There are 2 bolts to loosen up and pull the belt out slide the alternator down by the exhaust and pull it out by the CV axle
take off the drivers side tire, then the plastic splash gaurd. alternator will be right there
how do you replace 1997 alternator belt
To replace the alternator belt on a Citroen Berlingo, you have to locate the tensioner. You can loosen it to replace it.
The alternator on a Ford E150 van is replaced by loosing the retaining bolts, removing the belt, disconnecting the wiring harness, and unbolting the alternator. A replacement alternator can then be put into place and reattached.
Yes! The 1996 Ford Probe 2.0 is an Interference Engine. Serious engine damage will occur if the belt breaks. Replace the belt every 60,000 miles.
loosen the serpretine belt tension and remove the two bolt that hold the alternator
Remove the belt from your 1967 Ford Mustang alternator. Disconnect the alternator wiring. Remove the alternator retaining bolts. Reverse the process to install the new alternator.
BeltsYes, you must remove all of the belts to replace the alternator belt. The compressor belt first, then the power steering belt then the alternator belt.
Remove the neg battery cab;e then the wires on the alternator.. Disengage the belt and take the mounting bolts out of the alternator. There should be a routing schematic for the belt on the fan shroud.
your fan belt may be connected to your alternator if so loosen alternator romove belt put new one on and pull alternator back until proper tension is aqquired tighten
Remove the alternator belt from your 2003 Ford Mustang alternator. Remove the wiring harness from the alternator. Remove the alternator retaining bolts. Reverse the process to install the new alternator.