answersLogoWhite

0


Best Answer

The ignition "switch" on a 99 silverado isn't just a switch....it's a small wire harness that in the colum & under the dash.....if you look under the dash to the left of the colum...you will see a small block with a ton of wires and a red bolt in the center of it. this harness connects at 4-5 diff. locations in & around the colum....it typically runs about 250-300 $$. make sure that's your problem before ripping it out & buying a new one. if you have a "no start" situation......I would also check the starter (is there power to it when someone turns the key) the neutral safety switch (drivers side of the trans right above the shift link). If the key doesn't return on it's own from the start position then it's your ignition actuator rod in the colum. there is also a starter relay under the hood in the fuse box on drivers side....with the battery unhooked.....swap a relay with one of the others known to be good (headlamp relay is an easy check) hope one of these helps.........good luck

User Avatar

Wiki User

โˆ™ 2011-09-12 20:45:19
This answer is:
User Avatar
Study guides

Add your answer:

Earn +20 pts
Q: How do you replace an ignition switch on a 1999 silverado?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Do you need to replace the ignition lock cylinder when you replace the ignition switch on a Pontiac Sunfire 1999?

No, not if it is not defective. If the ignition switch is defective then that is all you need to replace.


How do you replace the ignition switch on1996 Saturn sl?

ignition switch saturn sl 1999


How do you replace the ignition switch on 1999 Malibu?

please give instructions on replacing the ignition switch on my 99 Malibu


How much to replace an ignition switch in a 1999 acura Tl?

the switch is about $55 and the labor is .5 hours (or about $50


Why won't my 1999 Chevy silverado stay running after i replaced a key tumbler?

The lock/tumbler has to be in time with the ignition switch. I suspect it is not.


How do you replace ignition lock 1999 vw beetle?

how to replace ignition lock for 1999 vw beetle


How do you change the ignition switch on a 1999 Kia Sephia?

Begin by removing the retaining ring at the top of your 1999 Kia ignition switch. Slide the ignition switch out and remove the wiring harness. Reverse the process to install the new ignition switch.


How do you remove the ignition switch on a 1999 Chevy Cavalier?

Remove the retaining ring from the top of your 1999 Chevy Cavalier ignition switch. Slide the ignition switch out and remove the wiring harness from the end of it.


How do you replace the wiper motor pulse board on 1999 silverado 2500?

how do you replace the wiper motor pulse board on a 1999 Chevy Silverado 2500


How do you change the ignition switch on a 1999 Cadillac DeVille?

You can remove the 1999 Cadillac Deville ignition switch by removing the retaining ring. The retaining ring will be at the top of the ignition switch. Pull the ignition switch out. Remove the wiring harness from the back of the switch. Reverse the process to install the new switch.


How do you replace an ignition switch on a 1999 RX300?

the library should have a shop manual for this vehicle, you can make copies of the right sections :)


Where is the brake light switch on a 1999 Chevy Silverado?

what does it mean if my brake light is blinking on and off when its pushed down in my 1999 Chevy silverado

People also asked