ALLRIGHT LAST WEEK ON THE WAY TO WORK I HAD MY BELT BUST ON ME. I DRAINED MY BATTERY BUT I MADE IT TO AUTOZONE WHERE I COULD GET EVERYTHING THAT I NEEDED SUCH AS A TENSIONER TOOL(RENTED FOR A REFUNDABLE $25 WHEN YOU TAKE IT BACK) AND THE BELT. I WOULD ALSO RECOMMEND TO CHANGE OUT THE BELT TENSIONER IN A WHILE IN ORDER TO CHANGE IT YOU WILL HAVE TO PLACE A JACK (FIND A GOOD STRONG SPOT YOU DONT WANNA PUNCH A WHOLE IN YOUR OILPAN) UNDER ENGINE BECAUSE I HAD TO SUPPORT THE ENGINE A BIT TO TAKE THE TWO OF THE BOLTS(I USED A LUG NUT CROSS TOOL THAT YOU WOULD USE TO CHANGE OUT YOUR TIRE) FROM A MOTOR MOUNT. THEN THE MOUNT SHOULD SPRING UP A LITTLE BIT AND GIVE YOU A GAP. NOW YOU CAN SLIDE THE BELT IN. USE THE DIAGRAM THAT CAME ON THE BELT PACKAGING OR LET AUTOZONE PRINT ONE OUT FOR YOU PLACE THE BELT IN THE CORRECT POSITION EXCEPT FOR THE IDLE WHEEL RIGHT OVER THE BELT TENSIONER. WITH THE TENSIONER TOOL SPRING YOUR TENSIONER COUNTERCLOCKWISE AND SLID THE BELT IN ON THE IDLE WHEEL. DOUBLE CHECK AND MAKE SURE THE BELT IS IN PROPERLY. NOW YOU CAN PUT YOUR BOLTS BACK ON THE MOTOR MOUNT. I TELL YOU TO DO THIS LAST IN SUCH OCCASION THAT THEY GIVE YOU THE WRONG SIZE BELT AS HAPPENED TO ME. YOU SHOULD BE GOOD TO GO NOW. ITS PRETTY EASY , IT JUST LOOKS COMPLICATED.
how do you replace the oil pump
how to locate and chage plugs
Engine oil with filter 4.5 quarts
Lift hood. If engine is missing, there will be a large empty space where the engine used to be.
how to replace the power steering hose on a 2001 oldsmobile aurora 3.5 liter engine
It is located on the passenger side on the bottom of the engine near the firewall.
A 3.8 of the same series from any GM Division. 3.4 do not share the same bolt pattern. 3.5 Intrigue engines are only in certain Intrigues and Auroras, and do not share the bolt battern with 3.8s. But this comes from someone who has put a 455 Toro in the rear of an S10, and a W-41 in a Fiero. Anything goes in anything if you are creative. :)
did u ever figure it out?
it is located inside the intake manifold
The torque specs for the rocker arms on a 2001 Oldsmobile Alero 3.4 liter V6 is 7.42 ft. lbs. It is 89 inch-pounds and 18.98 N-m.Ê
if you have the 2.2 liter ecotec engine, they are located right on top of the engine, they are located under the top black piece that says ecotec on it.
changing the crankshaft sensor