WARNING: THE EXHAUST MANIFOLD, EXHAUST PIPES AND CATALYTIC CONVERTER BECOME VERY HOT DURING ENGINE OPERATION. ALLOW ENGINE TO COOL BEFORE REMOVING OXYGEN SENSOR. # Raise and support the vehicle. # Disconnect the wire connector from the O2S sensor CAUTION: When disconnecting the sensor electrical connector, do not pull directly on wire going into sensor. # Remove the O2S sensor. Snap-On oxygen sensor wrench (number YA 8875) may be used for removal and installation. == Threads of new oxygen sensors are factory coated with anti-seize compound to aid in removal. DO NOT add any additional anti-seize compound to the threads of a new oxygen sensor. # Install the O2S sensor. Tighten to 30 N·m (22 ft. lbs.) torque. # Connect the O2S sensor wire connector. # Lower the vehicle.
where is the crankshaft sensor on a 1994 dodge pickup with a 5.9l engine?
Unbolt distributor cap. lift rotor off, remove and install new cam sensor (pick up plate) and reinstall rotor and cap.
The only engine speed sensor is the pick up plate in the distributor.
PO136 on a 2000 to 2003 Dodge Dakota (It may be true for other year Dakotas) means "Downstream oxygen sensor circuit problem (left cylinder bank)". This is the oxygen sensor that is located just past the catalytic converter on the driver's side and measures the oxygen level after the exhaust has passed through the catalytic converter. I
It does not have a crank sensor, it only has the "pick up" plate in the distributor.
No crank sensor, just the pick up plate in the distributor.
It is the "pick up" plate in the distributor.
It is on top of the rear axle
It is the "pick up plate" in the distributor.
if it doesnt have a crankshaft sensor then you have a distributer pick up. Its under your distributer cap.
A 1991 doesn't have a crank sensor, it only has a distributor pick up plate(cam sensor)
Four