answersLogoWhite

0


Best Answer

The only engine speed sensor is the pick up plate in the distributor.

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Were is crank positioning sensor located on a 1991 dodge pick up?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Where is crank sensor located on 1997 Dodge Ram van?

the crank sensor is located on the top front of the tranny


Where is the crank sensor on a 1993 Dodge Intrepid?

where is the crankshaft sensor located on a 1993 dodge intrepid


Dodge 3500 diesel crankshaft positioning sensor A where is it located?

Depends on year. 1989 to 1998.5 it is on the front above the crank pulley. 1998.5 to 2002 it is behind the starter. 2003-present it is below the crank pulley.


Where is the crankshaft sensor located on a 1991 dodge caravan 2.5L?

No crank sensor, only the sensor in the distributor.


Where is a crank sensor located for a 1990 Dodge Dakota?

Inside the distributor


Where does the 2003 Dodge Intrepid cam positioning sensor is located?

Front driver side of engine.


Where is the crank shaft sensor located in a dodge avenger?

The crankshaft position sensor is located on the top of the transmission. It is located close to the bell housing.


Where is the crank sensor located on a 1999 dodge stratus?

Drivers Side Grounded to the block.


Where is the crankshaft sensor located on a 1995 Dodge Caravan 3.0L?

the 1995 and before 3.0L's only have the sensor in the distributor. No crank sensor.


Where is the crankshaft sensor on a 1997 Dodge Caravan?

The Crank sensor is located on the transmission housing near the top at the back of the engine.


Where is the crank sensor on a 1999 dodge stratus?

The crank shaft sensor is on the bell housing of the trans, buy a new one and look for the plug end that looks alike. also if u are looking for the cam positioning sensor it is on the left side of the engine coming out of the valve cover.


Why does my 2002 dodge neon 2.0L sputter and stalls?

there is a sensor that is called a cam positioning sensor it is attached to the engine block which gets pretty hot try changing it. also there is one for the crank.