I just replced my girlfriends two weeks ago. The blower resistor is located behind the glove box in front of the the firewall. What you want to do first is unplug the blower because it will give you more room to access the resistor. And that will be held in place by three screws, so remove that and you will have a clear view. The resistor is help in place by two plastic rivots.
And those can be romoved with a flat head screwdriver or needle nose pliars.
Resistor is located behind the blower motor assembly.
The blower motor speed resistor is burned out. You can replace only the resistor but the resistor probably burned out because the blower motor is going bad. If you want to fix it for good, replace both the blower motor and blower motor speed resistor.
Check to see if you are getting power to blower motor - if so replace blower motor If not check fuse, switch, resistor pack.
its behind the blower motor under the passenger side of dash
Blower motor fuse is blown. Blower motor resistor burned out. Blower motor switch bad. Blower motor bad.
the resistor is directly behind the blower motor under the dash
Under the hood to the left of the blower motor mounted in the housing on the firewall...
Check to see if you have 12 volts at the blower motor. If yes then the blower motor is bad. If no, then the resistor, relay, or fuse is bad.
Your wiring is probably messed up, happened to me. Locate the wires from the blower to the controls check them and replace as needed. Assuming no wiring problem check and replace the blower motor resistor.
The blower motor resistor circuit board has gone bad. Replace the blower motor resistor. I did Still dont work Try the fuses...Had the same problem and it was a blown fuse.
To replace a blower motor on the resistor first you take off the nozzle and then you go into the motor through the nozzle and unlock it then repeat and oil and done.
# Locate the blower resistor under the right-side of the instrument panel # Disconnect the electrical connector from the blower motor resistor # Remove the blower motor resistor mounting screws and remove the resistor from the housing # Installation is the reverse of removal