Want this question answered?
Well I know its not 3/8 tried T-55 T-50 T-60 none worked
replacing achieva serpentine on a 96i have a 96 and you have to completely remove the motor mount and all of the bolts holding it on the engine to replace the belt,also carefully jack up the engine since it will fall on the ground if you take off the mount
It is located under the car close to the gas tank
First remove the negative battery cable. Then the lower a/c ducts then the wires and bolts that are holding it in that are under the dash. Then take off the knobs and remove the nuts that are under them and work it out..
Listed under the hood on a placard and in your owner's manual. .060 is the gap on a 2.4 liter
I am trying to do this myself,any suggestions ========== Do not turn transmission! I myself, 8/29/09
The knuckle could be heli-coiled if the damage is not too bad. If the stripped threads are on the caliper, replace the caliper.
Remove the upper intake and there it is.
Perhaps transmission fluid is "breaking down" at high temp. Try changing fluid and filter
Remove the two slider/anchor pins using a 3/8" Allen wrench and the caliper will come off.
The PCM is located at the back wall under the hood, next to the master cylinder, it's a black round tube like box that is mounted to the back wall.
In the Fuel tank