The sensor is located on the driver side of the engine on the end of the head just below the valve cover there are four screws that hold it on and a wire plugged into it . make sure the engine is cool before you try to change it as the coolant lines run real close to it will take about 1/2 hr to change it maybe a little longer if you have not done it before not real hard and cost about $30 at autozone and you will not have to reset check engine lite if its on as it should be if sensor is bad it will go out on its own! hope this helps
where is the camshaft position sensor located on a 1999 Oldsmobile intrigue
In order to replace the camshaft position sensor, you would need to disconnect the electrical plug holding it in. Using a socket, hold down the bolt and remove the camshaft position sensor.
The camshaft position sensor is located on the end of the camshaft housing, on a 2002 Daewoo. The sensor should be labeled as such.
Where is the camshaft position sensor located on 1990 Lexus ls400?
It is located on the backside of the engine. Go to youtube and type in how to replace camshaft sensor on 2005 Nissan altima and it will show where it is and how to replace it, that is how I did my one.
The Camshaft sensor is located in the distributor.
The camshaft position sensor is located near the thermostat housing. You should replace the crankshaft position sensor as well. This one is much harder to locate....it is on the backside of the engine that is between the firewall and the engine block. Both use the same sensor.
Do you have a video of the hhr camshaft position sensor
how do you replace the camshaft position sensor on a 1997 plymouth voyager 3l
The Camshaft Position Sensor is located behind the Power Steering Pump.
Where is the camshaft position sensor located on a 2003 Nissan Sentra GXE?
The camshaft position sensor is located in the engine compartment of the 2002 Daewoo Leganza. It is at the end of the camshaft housing.