0
First locate the connector for the Crank sensor. It's right below the oxygen sensor connection that you'll see coming straight out of the center of the exhaust heat shield. Once you've disconnected the Crank sensor connection you'll just follow the wire down to the sensor. It's one 10mm bolt to remove, and then carefully twist the sensor to wiggle it out (I haven't done mine yet, but I've read it's tight down there, and you'll likely need a wobbly socket and a 2" extension.) Inspect the old sensor to ensure the O ring didn't stick to the block. If the old O ring is stuck to the block, when you install the new sensor it will affect the clearance and give you problems.
Wiki User
∙ 10y ago
Add your answer:
Earn +20 pts
What is the cost of a crank sensor replacement for Hyundai accent 2002?
At autozone, they are $34.99.
Where is the crankshaft position sensor located on a 1996 Hyundai accent?
Crank Angle Sensor (location)i own a 98 Hyundai accent and the crankshaft position sensor is located just underneath the far right spark plug if your looking from the front of the car,about 5"-8". hope this helps.
Your 2001 Hyundai accent will crank but not start?
Probably need to check the crank sensor (if the check engine light is on) or the fuel pump... I had that problem not too long ago...
Where the crank position sensor is located?
where is the crank position sensor located on a 2004 hyundai v-6 2.7 engine
Where is the crank shaft sensor 2001 Hyundai sonata 4 cylinder?
its on the front off the engine you must remove timing belt to replace it
How do you remove window crank handle in 1999 Hyundai accent?
With a hammer and pry bar.
Do you need to replace cam sensor after replacing the crank sensor?
if you have a code w/ cam to crank reference then yes. if only a crank sensor issue the no
Where is crank shaft position sensor on Hyundai accent 1.3l 3 door 1998 model?
The HyundaiÊ1.3 liter engine crankshaft position sensor can be found on the back of the engine. You will need to remove the rear engine cover in order to access the crankshaft position sensor.
How do you replace crank shaft sensor on 2005 Chrysler 2005 300c?
How do you replace crank shaft sensor on 2005 Chrysler 2005 300c?
Where is the crank shaft sensor located on a Hyundai Elantra?
in front of the motor by the transmission
How do you know if the crank shaft position sensor is bad?
A way to tell if the Crankshaft Position has gone bad is if the engine has a strong kick (Turnover) but, does not fire or start.my 2000 Hyundai accent will not catch fire
Do you have to replace anything else along with the camshaft sensor?
Usually pretty common to have the replace the crank sensor or crank angle sensor. Before you do replace the camshaft sensor check that your timing is right on because this is the issue with about 75% of vehicles.
