by driving my car the hyundai elantra 01 stall out and i replaced spark plugs , cam sensor crank shaft position sensor and still not ignighte
where is the crank position sensor located on a 2004 hyundai v-6 2.7 engine
The ignition switch could be bad if a Hyundai Elantra has no crank and then starts. The fuses which are tied to the ignition should also be checked.
The crankshaft position sensor is located on the front side of the engine block near the flywheel/driveplate
The (CKP) crankshaft position sensor is located on the front side of the engine block,near the flywheel/driveplate.
where is located the crankshaft sensor in a Santa Fe 2001 2.7
on top of the bell housing in plain view
get it checked out by advanced auto parts they run a diagnostics for free just ask its and obd2
I am working on the same problem in a 1999 Elantra Wagon, and have read that it could be the crank sensor. Hope this helps. here are a couple of possiblities: bad crank sensor, broken or jumped timing belt, bad fuel pump, bad cam sensor. Answer was this the only problem or was the transmission not shifting before too?
It is located underneath timing belt cover, behind crank pulley.
the crank sensor is located just behind the crank shaft pully of the engine.
Where is the crank shaft sensor located in a Audi a6
That year did not have a crank sensor.
where is the crank sensor located on my 1997 Chrysler sebring lxi
the crank sensor is located on the top front of the tranny
Crank Angle Sensor (location)i own a 98 Hyundai accent and the crankshaft position sensor is located just underneath the far right spark plug if your looking from the front of the car,about 5"-8". hope this helps.
In the right side of motor, at drivers side, near the exhaust manifold. I is very dificult access it.
where is the crank sensor located on a 2002 Oldsmobile intrigue 3.5
The 1995 Oldsmobile Aurora 4.0 liter engine crank sensor is located on the back of the crank. You will need to remove the rear engine cover in order to view the crank sensor.
Location is behind the starter,droping the starter makes the job easy.unplug the sensor then pry it out,best with pliers o ring then reinstall.
It does not have a crank case sensor.It does not have a crank case sensor.
where is the crank sensor located on 2000 nissan sentra
where is the crank sensor located on a 2005 chevy impala
At autozone, they are $34.99.
The crank position sensor is located by the crank shaft on a ford 350 xl 5.8 liter.