answersLogoWhite

0


Best Answer

If it's anything like my 2007 Crown Vic, which it probably is, the trim piece the window switch is attached to just pops right out in a upward motion. You might be able to grab a hold of it and yank it up, or at least start prying it up with a screwdriver first. From there it just unclips from behind. I just replaced my switch, took a whole 2 minutes.

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you replace electric window switch in the drivers door on a 2003 crown Victoria?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you replace the electric window switch mechanism located in the drivers door on a 1996 Ford Crown Victoria?

See the link here to learn how to remove the window switch assembly (steps 1-3)... http://www.autoclinix.com/Mercury/Front%20Speakers2.htm


Where is the 2000 Ford Crown Victoria inertia switch?

On a 2000 Ford Crown Victoria : The fuel pump inertia switch ( shut off switch ) is in the trunk , behind the trunk liner on the drivers side ( there is an access hole )


How does a passenger window stop in the down mode and all other windows work properly what could be the problem?

Replace the switch ! It is really not that expensive and it will fix the problem !! If it works from the drivers door replace the switch on the door that doesn't work ! If it works at that door replace the drivers switch ! KM


Where is the 2001 crown Victoria rear air shock off button?

On a 2001 Ford Crown Victoria : The air suspension switch is in the trunk , on the drivers side ( there should be a label beside the switch )


Where is the fuel pump relay on a 1987 ford crown Victoria?

The 1987 Ford Crown Victoria fuel pump relay switch can be found on the firewall in the engine compartment. The relay switch will be on the drivers side of the firewall.


How do you fix electric windows in Chevy celebrity?

How to repair electric windows depends on what is wrong with them. If the motor that runs the window has burned out then replace the motor. If the switch is faulty then replace the switch. Check for broken wires, repair them if found.


How do you replace the driver's side electric window switch on a 1992 Acura Integra?

The driver side electric window switch on a 1992 Acura Integra is reached by removing the door panel. Unbolt the switch from the mounting bracket and disconnect the wiring from the harness. Replace the unit.


Why will drivers side electric window not roll down when all others will?

Busted switch, motor or wiring.


How do you fix switch on drivers seat?

most likely its the switch. check the wire clip for a good ground and positive wire if both are good replace switch


How do you remove the passenger door panel on a 96 camaro in order to replace the electric window motor?

pop the clips that are holding the Electric window switch and pull the switch out replace it and place it back in with the clips. if you broke the clips you will have to replace them. they only cost 1.05 at Chevy shop....


Why does the power windows work independently but not when controlled by the drivers side switches?

more than likely you will have to replace the drivers side master switch


How do you fix a 99 Voyager drivers power window that won't go down and only makes a buzzing noise from the switch?

Replace the switch.