Electric Windows
Chevy Camaro

How do you remove the passenger door panel on a 96 camaro in order to replace the electric window motor?

345

Top Answer
User Avatar
Wiki User
Answered
2011-09-12 20:32:51
2011-09-12 20:32:51

pop the clips that are holding the Electric window switch and pull the switch out replace it and place it back in with the clips. if you broke the clips you will have to replace them. they only cost 1.05 at Chevy shop....

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


Begin by removing the inside passenger door panel. Remove the wiring harness from your passenger side electric mirror. Remove the mirror retaining bolts. Reverse the process to install your new electric passenger side mirror.

It is necessary to either remove the passenger side fender or inner wheel well to access the heater fan in a 68 camaro.

how do you replace a drivers side mirror on a el ford falcon

remove the complete dashboard and then replace it

in the gas tank. you have to remove the tank to replace the pump.

(1) disconect battery ( 2) under hood on passenger side remove 2 10mm boltes (3) pull ecm out disconnect 4 wire pluges

passenger side of the pumpkin. use a 3/8th ratchet to remove it.

Unfortunately you will have to remove the engine to get at it.

The 1975 Chevrolet Camaro heater blower motor can be found behind the passenger side dashboard. You will need to remove the passenger side kick plate in order to access the heater blower motor.

On driver side, you will have to remove the steering assembly. With the passenger side you should only have to remove the factory manifold.

Remove the inside door panel of your 1993 Chevrolet Lumina. Remove the passenger mirror wiring harness. Remove the passenger mirror retaining bolts. Reverse the process to install the new passenger mirror.

remove the plastic panel and there are 3 ten mm nuts remove and replace mirror.

Remove the passenger side wheel well liner and it's to your left, remove lines and replace.

How do you remove back door panel off 2005 grand marquis

drop the tank remove pump replace pump replace tank. put back together

How do you remove the headlight assembly on a 2001 camaro?"

to replace the passenger side mirrior you remove passenger door panel then the bolts that hold it on will be right there just take them off and put the new one back on

Remove the water from your 2002 Chevrolet Camaro cooling system. Remove the water supply hoses from the heater core. Remove the heater core retaining bolts. Reverse the process to install the new heater core.

Remove the wiring harness from the back of your 1993 Chevrolet Camaro blower motor. Remove the blower motor retaining nuts. Remove the fan from the front of the blower motor. Reverse the process to install the new blower motor.

remove the panel from the bottom of the dash on the passenger side and look up into what would be inside of the dash and its right above you.

remove the retaining screws. pul oyt headlight and unplug it. plug in the new one and replace the retaining screws.

Simply remove the 4 bolts holding it on and replace it.

remove the nuts from the u bolts and remove the bolts. Install new ones and tighten the bolts.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.