Remove the inside door panel of your 1993 Chevrolet Lumina. Remove the passenger mirror wiring harness. Remove the passenger mirror retaining bolts. Reverse the process to install the new passenger mirror.
To replace the passenger side view mirror you will have to remove the inner panel of the passenger side door to get to the three nuts that hold the mirror in place. To begin you will need to remove the inside handle of the passenger side door (there are two screws holding the handle in place) they are relatively easy to remove with a socket head screwdriver. You will need to pop off the handle insert to see the first screw. The other screw is under the electric window control pushbutton cover. Just pull that cover up to see the second screw. Also you will have to remove the connector from the electric window switch to remove the door panel. The electric window switch just unplugs from the backside of the switch. After you have that removed then pry the door paneling off the door which is held by snap in plugs around the perimeter. You will then be able to see the three nuts that hold the side mirror on to the door. Also you will see the electric connector for the mirror motor that you will need to unplug to remove the mirror.
Chevrolet Lumina. Remove the wiring harness or the mirror linkage. Remove the mirror retaining bolts. Reverse the process to install the new passenger side mirror.
Passenger mirror access is same as drivers side. Three screws accessible inside door panel to remove entire mirror assembly. To remove mirror within the mirror assembly it just pulls off - snap fit of mirror mount to drive.
remove door panel then remove screws behind mirror. remove door panel then remove screws behind mirror.
on top of door panel behind the mirror. remove the plastic cover by prying it off. remove the mirror nuts, and then remove mirror. if it has mirror adjustment cables on it. just remove these cables, and put on with new mirror if needed.
* Remove the mirror trim cover from the door panel * Remove the three mirror retaining nuts and detach the mirror from the car
# Remove the door trim panel and watershield.Disconnect the electrical connector from the mirror # Remove the retaining nuts and detach the mirror from vehicle
You need to remove the door panel. Remove the wires going to the mirror. Remove the nuts holding the side mirror. Reinstall in reverse order.
The passenger side mirror on a 2001 Toyota Sienna is mounted by screws. To replace the mirror remove the mounting screws and unplug the wire clip.
Remove the plastic on the inside of the door oposite of the mirror there are 2 bolts that hold the mirror to the door and then you will need to disconnect the three wires that are attached to the motor it is easiest to remove the actual glass mirror from the housing in order to get to them but the glass pops out pretty easy so it is no big deal. it takes about 5 min to remove and reinstall. hope this helps and good luck.
If you have an electric side mirror you have to remove the door panel then unplug the electrical connector and then remove the screws that hold the mirror.