You have to remove the splash guard inside the wheel well to access the lamp 1. Turn the wheel to the outside to access the two screws towards the front of the wheel well. 2. You then need to remove two plastic plugs connecting the wheel well splash guard to a "body side" splash guard. Note that there are two screws that connect the splash guard to the bumper. These screws are accessible from the bottom of the bumper. You may want to jack up the vehicle to gain access to these screws. 3. Now note that I didn't remove the entire wheel well splash guard. By removing the screws at the front I was able to push the guard aside to access the bulb. 4. It was difficult to remove the wire harness cable from the bulb. The plastic clip that secures it in place is much like the one on the headlamp and it is located (at least mine was) towards the bottom of the vehicle. You have to release this plastic clip to disconnect the wire harness. 5. Disconnect the harness 6. Then I had to use a needle nose pliers to rotate the lamp counterclockwise to remove it from the socket. 7. Using the needle nose pliers I then inserted the new lamp, turning clockwise to secure it in place 8. Connect the wire harness 9. Re-connect the splash guard Good luck.
how do i change the bulb in the clock on 2004 lincoln town car
Open the hood, twist/unscrew the grey colored lamp holder and replace the bulb.
how to replace lincoln town car 2004 ultimate clock bulb
how do you take out the front signal lamp on a 2004 range rover
how to replace tail lamp 2005 xterra
How do you replace the fog lamp bulb on Kia Sedona 2007?Read more: How_do_you_replace_the_fog_lamp_bulb_on_Kia_Sedona_2007
Do it the normal way with a florescent bulb
how do I replace a parking lamp (left) on a 1996 Ford Taurus
Get a flat head screwdriver and pop it off...then replace the bulb
To remove the fog lamp bulb just pull the plug off the back of the bulb and turn the bulb one quarter turn and it will come out. To remove the high brake lamp bulb you need to carefully pry the plastic cover off then there are two Phillips screws that remove the whol lamp assembly then just pull out the bad bulb and replace
how do i remove and replace my fog lamp bulbs on my 2006 bmw 525i
== # Remove screws attaching license plate lamp to rear bumper # Remove lamp from bumper. # Remove bulb socket from lamp. # Pull bulb from socket. == # Install bulb into socket. # Install bulb socket into lamp. # Place lamp in position. # Install screws attaching license plate lamp to rear bumper.