Want this question answered?
how to replace front disk on liberty 02
There is a single screw above each front parking light assembly. You will need a 7mm socket to remove the screw. After the screw is removed, simply pull on the assembly from the back corner and pull straight forward.
It is a 36 MM socket
To replace front parking light on a 1999 Ford Taurus, lift the hood and remove the bolt holding the parking light housing cover. Twist the parking light off and replace with a new one.
Open the hood; there is a small Phillips screw at the front corner of the fender above the parking light housing that has to be removed. Once removed, grasp the parking light housing and pull forward out towards the front; there is a pin at the lower portion of the housing that has to be pulled and un-seated from it's socket. It's not a screw, it will release with outer pressure. Once the housing is out of the truck, the bulb socket can be removed from the housing by turning the socket slightly to release and remove it. Reverse the process after the bulb is replaced.
Front or back?
The parking lights on the front of the car are accessible from the underside of the car. It's a tight squeeze to get your hand up in there because of the spoiler. When you get your hand on the back of the socket turn it 1/4 turn and pull it out. Dan
carefully
Gently pull on the grill. It is held in place by GM standard clips that should pop right out. You may need a large flat head screw driver to help in some spots along the top near the hood latch. The grill and parking light housings should all come out in one piece. Once popped out the wiring harnesses for the parking light should prevent you from completely removing the grill. There you will see the socket. Simply hold down the tab on the socket turn and pull out revealing the bulb. After you replace the bulb do the reverse to replace the socket and then the grill. Be patient in aligning the tabs as you replace the grill.
Remove the headlight assembly and you will have access to the parking light bulb.
I get everything out of a junk yard
Gain access to the rear of the socket. Unplug the wires from the rear. Unscrew the housing and the socket will come out the front.