Want this question answered?
Open the hood. Near the front of the turn signal assembly there is a Phillips head screw. Loosen but do not remove the screw; it releases the front of the assembly. You then need to pull forward to release the pin holding the rear of the assembly. Reverse the above to replace the assembly.
It looks as if I'll have to crawl under the front of the car to access the bulb to replace it.
The front turn signal assembly will pop out with a little help. It is held in place by clips that snap it into place.
look in your owner's manual
Reach behind the bumper of the 99 Cavalier. There are two nuts that hold the turn signal assembly in. Remove the nuts to take the assembly off and replace it.
i need to replace a throttle sensor and put a throttle body rebuild kit in
rear you use a torx driver to remove taillight assembly screws. them replace bulb.
how do i replace front wheel bearinbs on 2000 ford ranger 4wd
Remove headlight assembly to access bulb/socket.
Unplug the whole light assembly from the bottom front of the car it just pops out to replace the turn signal bulb-same on the rear but you have to remove the trunk lining first.
Remove the headlight assembly above the faulty signal bulb. This will give you access to the signal bulb socket. To remove the headlight assembly, open the hood, stand in front of the headlight assembly, notice two black tabs sticking up behind the headlight assembly inside the radiator support. Pull up and wiggle the tabs to remove them, this will release the headlight assembly. You can now wiggle the headlight assembly out to gain access to the signal bulb socket for replacement.
To replace the turn signal switch of a 1996 Dodge Caravan, open the engine's hood to access the front turn signal bulbs. Then take the headlight assembly a little off the front to give room to get the bulbs. Remove the old turn signal switch and slip the new one in place.