Head Gaskets and Valve Covers
Ford Ranger
Honda Civic EX
Chevy Cavalier Z24

How do you replace head gaskets on a 1992 Chevy cavalier z24?


Top Answer
User Avatar
Wiki User
2008-07-31 18:27:40
2008-07-31 18:27:40

The best way is to remove the upper and lower intake. Then loosen all the rocker arms and pull the pushrods ( need to go back in same place during reassembly). remove the head bolts pull the heads off. clean and check, the put it all back together. May have to use new head bolts.


Related Questions

how do you replace ignition switch on a 1992 Chevy cavalier 2.2 4 cylinder

Go to the auto zone for parts and instructions

i would like to remove the backseat from my 1992 chevy cavalier

In the gas tank. Costs about 300-500 dollars for a shop to replace it..

The directional flasher for a 1992 Chevy Cavalier is under the dash. It is mounted on the drivers side, beside of the steering column.

YES, Remove all old gaskets and replace with the NEW ones.

how do you replace a CV joint on a 1992 Chevy pickup?

Do you have a picture of location of crankshaft position sensor for 1992 Chevy Cavalier 2.2L ohv engine?

That is referred to as "back dating" and it is illegal at the federal level.

You can check your automatic transmission fluid in your 1992 Chevy Cavalier with the transmission dipstick. The dipstick will have marks that indicate whether it is full or low one quart.

Head gaskets can go at any time. Everything will be going just great and then..."POOF" bad head gasket. But you must remember this thing is 19 years old, and after 10 years useally the only thing that works is the check engine light.


yes it does and depending on the engine some have more then one

Knowing the firing order of a cars engine can help diagnose car problems. The firing order for a 1992 Chevy Cavalier is 1-2-3-4-5-6.

Simply remove the 4 bolts holding it on and replace it.

its located at the rear of the engine (center) attached to the block

try your chev dealer and they should be free

In the center console, below the trap door.

It will take an experience mechanic approximately 8 hours to replace the timing belt in your 1992 Chevy Corsica. The 1992 Chevy Corsica does not have each timing chain, it has a timing belt.

No, they can be replaced with the engine in the vehicle, but it is not an easy repair.

Usually in housing at engine end of upper radiator hose

Remove the cylinder head from your 1992 Chevy 350 cubic inch engine. Remove the head gasket and clean the surface. Put the new head gasket on and reverse the process.

its on the passerger side by the front wheel under the power steering.

Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.