Yes, the headlights should be completely identical.
How do I replace the power window switch on 1977 Corvette coupe
go to http://www.supermotors.net/registry/media/611233
A Corvette that was built in late 1976 up to late 1977.
what is the process for installing new seat covers in a 1977 chevrolet corvette
Spark plug gap for a 1977 Corvette using ACDelco R45TS is .035
You can find a diagram of a 1977 Corvette horn assembly at your local library. Look in the car repair section for a Corvette repair book.
== == more than likely your dimmer switch is bad,hope that will help
No, the last year for the Corvette to be called a Stingray was in 1976.
Most older GM headlight switches are removed by (diconnect battery) reaching under dash to the headlight switch and depressing the small release button at the top of the switch while pulling on the stem for the switch then unplug the wire harness. There is a stem nut behind the knob that fastens the assy to the dash surface.
The fuse box in the 1977 corvette is on the outside wall under the dash on the drivers side - about as far up in the corner as they could put it.
I think $8500
The 1977 Corvette 350 LS has ignition timing standard in this model. The purpose of the ignition timing is to help start the car in synchrony.
The fuse box on a 1977 corvette is located at the top of the kick panel on the drivers side. It is just below the dash on the outside wall............7T77T7
Depends on the model of the vehicle. Older models have the switch on floorboard. Newer models have the switch on the steering column. Can not say unless you specify make and model. Corvette 1977
Every Corvette since the first one has fuel injection. Corvette was the first fuel injected automobile in the US. Every Corvette since the first one has fuel injection. Corvette was the first fuel injected automobile in the US.
No the back spacing is wrong, c-4 to c-6 does not work, GRR
A roadster is a convertible. The Stingray was the 1969-1977 Corvette model. The 1968 was the same body style, but was not called Stingray.
Take the screws out of the metal headlight ring and the headlight will come right out.
Horsepower is not a unit of mass.