Want this question answered?
intake manifold
It depends on if it is a I4 or the V6. The inline 4 PVC valve is located on the side of the engine block, under the intake manifold. The V6 PVC valve in the valve cover of the cylinder bank next to the firewall. It is on the driver's side, near the throttle body. You can follow the rubber hose from the intake manifold down to the PVC valve. The Valve has a tab that locates it when it is screwed in/installed.
for the 2.3L 4 cyl. motor, it sits on top of the plastic intake manifold which faces the radiator.
At the rear of the intake manifold
There are 2 of them, And they are underneith the intake manifold.You will have to remove the intake manifold to get to them.
89 in. lbs
The sensor should be located on the intake boot(air intake system) or on the intake manifold.
There are two knock sensors on your engine, and they are underneath the intake manifold. You will have to remove the intake to get to the sensors.
No, a 2006 Mazda 6 does not have a voltage regulator mounted to the alternator. This is a part that one can replace on its own with the proper tools and instructions.
Some problems with the 2006 Chrysler 300C are the engine failing and a defective intake manifold,both are very rare.
on the intake manifold under the plastic cover on top
under the car, it runs from the gas tank to the fuel rail on the intake manifold.