89 in. lbs
intake manifold
for the 2.3L 4 cyl. motor, it sits on top of the plastic intake manifold which faces the radiator.
At the rear of the intake manifold
The 2006 Ford Escape's engine produces 152 ft-lbs. @ 4250 rpm.
There are 2 of them, And they are underneith the intake manifold.You will have to remove the intake manifold to get to them.
The sensor should be located on the intake boot(air intake system) or on the intake manifold.
There are two knock sensors on your engine, and they are underneath the intake manifold. You will have to remove the intake to get to the sensors.
The 2006 Impala has 3 different motor options, on the 3.5 the map sensor is located on the rear(left side of motor) of the upper intake manifold under the black bracket that the spark plug wires are routed over. You have to remove the two upper intake manifold bolts to remove it. The bolts have a torque spec of 18 lb ft, and a small amount of thread locker is recommended by GM after reinstalling them.
in the engine. you must use a number 2 flathead screwdriver to loosen the driveshaft to get to it. Remember to remove all of the wheels first! NOTE: do not adjust the tension of the chassis.
Some problems with the 2006 Chrysler 300C are the engine failing and a defective intake manifold,both are very rare.
on the intake manifold under the plastic cover on top
under the car, it runs from the gas tank to the fuel rail on the intake manifold.